Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

cup placement for concealed hinges

Posts

cup placement for concealed hinges

#1

cup placement for concealed hinges

Bill H - Evansville, IN

>I am using 1 1/4" full overlay concealed hinges (face frame) for some cabinets that I'm making. If I move the cup close enough to the edge of the door to get a the full 1 1/4" overlay that only leaves me 1/8" of material between the cup hole and edge of the door. This seems like too little material left on the edge of the door. Am I doing something wrong? Is 1 1/4" a nominal measurement? Will I only get ~1" of overlay out of these hinges?

Thanks in advance,

Bill

Re: cup placement for concealed hinges

#2

Sounds about normal

Lee Schierer - McKean, PA

>I have limited experience with cup type hinges, but that amount of clearance to the edge of the wood is typical for what I have seen. Unless your door is particularly heavy it should work just fine. If it is a really heavy door consider using 3 or 4 hinges.

Lee

Re: cup placement for concealed hinges

#3

Ellis Walentine

It's normal

Ellis Walentine

>I've used many Euro-style hinge brands over the years and they all end up with from 4mm to about 6mm between the cup hole and the edge of the door when properly installed. Keep in mind that the screws or plugs are what hold the cup to the door, so the cup itself exerts very little force on the edge of the door. It is more for restricting any movement in the x-y plane. The actual relationship of the door to the cabinet is determined by the adjustable hinge mount that gets attached to the cabinet wall or face frame.

Ellis Walentine, Host

Re: cup placement for concealed hinges

#4

Re: cup placement for concealed hinges

John Foster

>I agree. on my maple cabinets I have had to cover my errors a few times, and place the cups with just a paper thickness of wood between the cup and the door edge, and no problems.