>well I have a slight problem. I have about 14 lenghts of air dryed big leaf maple they are ~11' by 1 1/2' thick x 10" to 12" wide along with 15 ~ 11' by 1" thick x 8" to 10" wide boards. I also have 2 pieces of alder 11' long by 2" thick 12" to 14" wide. The problem is they are out in my enclosed trailer. I am wanting to sell the trailer so I have to move them into the basement shop. I don't have straight access to the shop so no matter how I try they will not fit in full length. I am not sure what I will build with them or I will just sell them out right but I need them moved. So what is a good length to cut them into so as not to waist to much. Say in thirds or in half 40" each. 8' is about the longest I can make it into the basement with. Thanks I hate problems like this.
I have that problem every time I buy hardwood, because of the short bed length of my little Mazda P/U, and the even shorter length of SWMBO's patience and understanding of woodworking exigencies. The last time I stored long lengths of lumber inside the width of our home they ran thru the living room into the dining room, and prevented the front door from opening. She was very vexed at me after 6 months. That surprised me bacause it never bothered me to use the kitchen door.
Most of the furniture I make lends itself to three and four foot shorts. So, I lop off that much and leave the rest to be cross cut later to fill the later requirements. I don't really feel that I have lost much lumber in the process.
I can't help with your wood question, but I may be interested in your enclosed trailer. If you haven't already sold it, send me an e-mail with size/condition/price info. I won't be home for a couple of days, so bear with me if I don't get back right away.
>I have a similar problem when I buy steel, since it comes in 20' lengths and is a little too long to haul unless I take a trailer. If I don't have specific uses planned, I generally cut some 12'-8', and some 10'-10'. If I cut them all in half I'll almost certainly need an 11' length! (fortunately, steel is a lot easier to join than wood)