Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Small Display Case Joinery

Posts

Small Display Case Joinery

#1

Small Display Case Joinery

Ron Berlier

>Greetings all,

I want to build a small display case for a doll (about 5" in diameter and 10" tall) that my wife has. I will either use 1/8" picture fame glass or 1/8" acrylic sheet material. The case will have a solid base, but all sides and top will be clear material. If I were to use something like 3/8" square oak and 45 degree miters what would be the strongest method of securing the miters?

If 3/8" really isn't the best size, what would be your recommendation?

As always, thatnk you very much, in advance, for you assistance.

Re: Small Display Case Joinery

#2

Re: Small Display Case Joinery

Rob Stokes in North Vancouver

>I'd run full length splines (look closely at the lower left corner of the left box in the picture linked below). These were done in 3/8" stock without a problem, but your box will be taller.

I'd mill the stock to 3/8", leave it wide, cut the mitres, cut the spline grooves (using both sides of the wide stock) and then cut the pieces off you want to use for box corners. Leave the pieces long and cut a groove in the fresh cut edge to accommodate the glass. I's use a router table and small (1/8"??) straight bit for this as it would be a little hairy running this stock over a table saw. Either way, use feather boards and push sticks.

When you cut spline stock, plane your stock to thickness (you'll want a fairly loose fit - looser than you think as you'll need room for alignment and glue) and x-cut pieces off so the grain is perpendicular to the mitre slot. Use multiple pieces of spline stock in the grooves,. Leave 1/4" between each piece of spline stock for expansion contraction.

putting a dab of glue at the center of each of the spline pieces but not gluing the ends, glue the corner pieces together to form the corner posts and clamp (masking tape works well). Cut to length after the glue dries and carry on with the rest of the box.

If you *really* want to get tricky, this same corner post "stock" that you made up could be used in a three-way-miter to also form the bottom and top of the box, using 1/8" plywood instead of glass for the panels.

good luck!

Rob


img

Re: Small Display Case Joinery

#3

Re: Small Display Case Joinery

Ed Mulligan, Cape Cod

>Ron -

A couple of alternatives to miters ...

Make the corner material square in section, run the grooves for the glass, and assemble with silicone. There's not much meat left in 3/8 x 3/8 corner material after you run 1/8 x 1/8 grooves. I'd use 1/2" square stock for better strength,

or

Glue the glass pieces together with silicone, like an aquarium. Add decorative wood trim to suit. I think this will be far stronger than the method above.

Ed