Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

What's Up with Power Feeders?

Posts

What's Up with Power Feeders?

#1

What's Up with Power Feeders?

Thomas Skaggs, Foothills of Mount Level

>So I have a project coming up soon where I will mill my own lumber for a hardwood floor. I don't have a power feeder but started wondering if milling a bunch of lumber would justify the expense. So it would be for my 12" jointer.

What are the upsides or downsides to power feeders? What features etc. should I look for? Does the size (width) of my jointer matter when choosing? Recommendations?

Thanks in advance,

Tom

Re: What's Up with Power Feeders?

#2

Re: What's Up with Power Feeders?

Bill Earl

>Don't have one on the jointer (yet), but I have one on the TS and one on the shaper. I find them to be an excellent investment in both productivity and safety. My hands never even get close to the dangerous action.

I wouldn't bother with the 'baby' feeders. I found them to be underpowered and a pain to adjust. For something like a jointer, I'd be inclined to go with at least a 1hp model.

Re: What's Up with Power Feeders?

#3

Thomas, there was a discussion here

Keith Newton, LR, Arkansas------WebKitFormBoundary

>about 3 months ago. Someone on this forum bought one especially for the jointer. It looked pretty good to me. While I don't mind getting exercise while I work, my joints are giving me more pain than I really like. Which makes me wonder if the pain means it is bad for me. Or would it just get worse if I didn't work through it.

Re: What's Up with Power Feeders?

#4

Re: What's Up with Power Feeders?

Dan Mitchell

>Bill - What feeder are you using on your TS? What model saw?

Thanks

Dan

Re: What's Up with Power Feeders?

#5

Re: What's Up with Power Feeders?

Bill Earl

>Dan,

I have a Grizzly 1/2 hp feeder on my Unisaw.

I have it mounted to a steel plate which can be attached in one of several locations behind the fence. It attaches via T-nuts in the extension table.

Re: What's Up with Power Feeders?

#6

Re: What's Up with Power Feeders?

Fred Davis

>Tom ,

I have Delta power feeders on my router table and Unisaw, which is a dedicated rip saw.

They may be "babies" , but they handle stock which you normally use in a cabinet shop.

If I was running a resaw operation , more power would be in order.

That being said , why would you install one on your jointer?

If you want fast parallel edges on you stock , rip it to a width slightly wider then you need and bunch up the boards and run them through your planer edges up.

For any run of consequence for the T and G operation , the shaper is the most efficient by far. There is where the power feed earns it's keep . ;-))

FredD

Re: What's Up with Power Feeders?

#8

New and Improved

Bill Earl

>Looks like the current model has a longer reach (a good thing!), but otherwise it appears the same.

I won't be near the shop for a few weeks, so I don't have pics. If you have any questions, feel free to contact me by email. (remove the "nospam" in the address)