Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

Need sanding advice

Posts

Need sanding advice

#1

Need sanding advice

Tom Pilsbury (Chicago)

>Anybody got any tips on sanding small parts? I made these earrings from some leftover bloodwood and maple and just about tore my fingers to pieces trying to sand the tiny things. I'd like to do a better job next time. TIA


img

Re: Need sanding advice

#2

Re: Need sanding advice

Peter Gregory

>I would try putting them on one of those no slip mats, they sell to put in the bottom of drawers. If they didn't work, a drum sander, maybe? I bet the mat would work for you.

Re: Need sanding advice

#3

Tag ! You're it ! . . .

steve mackay

>Been makeing wooden models a LONG time and itty bitty parts are my main selling point and there ain't no way around it. I have'nt needed to clip my thumbnails in YEARS ! Sanding this stuff keeps them SHORT. Best I've found is to sand everything down to, at least, 220 BEFORE cutting it loose from the stock. Then all you should have left is the cut edges. Those ARE good looking ! I know clamping those two stocks is sporty work !

Re: Need sanding advice

#4

Re: Need sanding advice

Richard Jones

>What I do.........

I use the velcro pad from my sanding disk and chuck it in the lathe. It's much easier to hold the piece and take it to the sandpaper than the other way around.

If no lathe, you could do the same thing with a rigged-up foam block chucked in your drill press.................

A drum sander always seemed too hard-backed to me, but it may work for you. The foam in a sanding disc pad seems a bit softer.

I make lots of jewelry, earrings, etc., this is the easiest way that I've found. Speed with a 2" disc is around 400 max.

Let me know if you need more info, and good luck.

Rich in VA

Re: Need sanding advice

#5

I know how, but......

Clint Searl, at the base of Haycock Mtn

>I won't tell unless I see you wearing them.

Clint

Re: Need sanding advice

#6

Bart Goldberg

Re: Need sanding advice

Bart Goldberg

>I would glue the sandpaper to a flat surface such as your table saw wings using psa sanding disks for example and rub the parts against the paper.

Bart

Re: Need sanding advice

#7

Re: Need sanding advice

Alexander Grigoriev

>How about using a small flat scraper? Does wonders. Why people are so inclined to spend time with a noisy dusty power sander, when just a few passes of a little metal card do the trick, and even better.

I'm using "super hard" scrapers sold by Lee Valley. One thing to note - it's very difficult to put a burr on those with a steel burnisher; you pretty much have to use a carbide burnisher.

Re: Need sanding advice

#8

Re: Need sanding advice

larry in kansas

>I think Alexander has a good idea, but if you don`t want to do that, how about putting some double face tape on your earrings and then tape that to a little bigger board and sand it by holding the bigger board. Or maybe you could use velcro instead of tape. Larry in Florida for now instead of Ohio

Re: Need sanding advice

#10

Re: I know how, but......

Tom Pilsbury (Chicago)

>Awwwww man! Now I'll have to go and get my ears pierced.