Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

toolchest

Posts

toolchest

#1

toolchest

James Clair

>I have been asked to build a standup rollaround toolchest. I would like to find some plans to work off of. Mostly solid oak with full extension tracks. Looking to reproduce an old 1920-40's machinist toolchest. Also, need the hardware for the drawer pulls. Any suggestions on the finish would help.

Re: toolchest

#2

Re: toolchest

Paul Woolson

>I'm pretty sure I've seen plans in Woodsmith magazine. They always have sources for the hardware listed in their plans.

As to finish, I think I'd be inclined to use oil. The thing is going to get banged up over the years. I think it would wear better overall if you didn't get finish dings (chips) but rather dents in the wood from the bumps it will take. In 100 years it will look wonderful!

Re: toolchest

#4

Why, LV, of course !

steve mackay

>

Re: toolchest

#5

Re: toolchest

James Clair

>What oil would you use and how do you use it? I have heard about linseed oil but never used it. I have always used sprayed on lacquaer. I do know that it is not very ding proof, and hard to patch. Any help on the finish would be great.

And thank's for the plans. More ideas would help make it unique.

Re: toolchest

#6

Re: toolchest

Kneale Brownson Dreaming of the Snow in N. MI

>I'd use pure tung oil. A lot of the other oils have a varnish in them. Tung gives a nice patina to oak and, if sanded lightly between coats, builds to a sort-of glowing sheen by about the third application.

Re: toolchest

#7

Re: toolchest

Edward in Vancouver

>Just finished my toolchest, plans were purchased from LV, similiar to a Gerstner style toochest. This chest features box joints, frame and panel back and removable front, 6 half-width drawers (1", 11/2", 2") and two full width drawers (2" and 3")

However--these drawers slide on traditional hardwood runners, not full extension.

After reading through B. Flexner's book on finishing, (several times!) I finally decided on 3 coats of plain old oil-based varathane. Most of the hardware came from LV too.