Framing Air Nailer
Howard
>Recommendations please - all my other nailers are Senco, do you prefer coil nails or a straight magazine? Thanks for the input.
Knowledge You Can Build On — Est. 1998
Framing Air Nailer
Howard
>Recommendations please - all my other nailers are Senco, do you prefer coil nails or a straight magazine? Thanks for the input.
Re: Framing Air Nailer
Mark Mandell - Gone Round In Jersey
>For Homeowner and one-man "shop" work, handyman, remodeling, light additions? Paslode F350S. Gun is bullitproof, fits between 16oc joists, jam-free.
Higher volume work in LVL and engineered materials? Hitachi NR83
mm
/\ /\ /\ /\ 2nd the Paslode
Kneale Brownson Dreaming of the Snow in N. MI
>I've run multiple big boxes of both framing and sheathing nails through my F350S with no misfires and no jamming.
Re: Framing Air Nailer
Barry Irby
>Whatever you buy, it might be good to be sure it shoots round head nails, not clipped head. The codes are eliminating the clipped head nails.
I have an old Senco framing nailer and I like it, but it is really heavy. Had it serviced recently and they were marveling at how far they have come since I bought this one. It is indeed a bear. All my guns are Senco and I have no complaints other than I hope they knocked a pound or two off the framing gun.
Re: Charlie Brown Nails
Mark Mandell - Gone Round In Jersey
>The Hitachi I mentioned is a full-head nailer and Paslode in making full head nails for the F350S although it was originally a clipped-head gun.
Re: Framing Air Nailer
Fred Davis
>Like you , all of my nail guns are Senco and the framing nailer which I havn't touched in three years is angled clip fed like my finish nailers. Nail guns that can handled 8 to 12 to 16 penny nails can be very dangerous to use , particulary if you havn't had the experience of one double tapping when you thought you was only shooting once.
Prtect your eyes and keep your free hand out of range.
FredD
Re: check your local suppliers
Larry Clinton At Frankfort (Central)., Indiana
>For nails and prices of the nails. I have a light Senco framing nail gun (think it is #8 gage - 2 5/8") - I also used my oldest son's Hilti 16 gage -clipped head when I built my shop. The gun worked great but I had a heck of a time finding nails for it. I ended up ordering them off the internet. Freight made the cost real high. I would see what is used in your area as I think most Hilti, Porter Cable, Senco etc. are good guns - but you sure do need to be able to find the nails for them. One other thing, clipped head nails are not approved for use in some areas. In Indiana they are fine, and I really see little if any difference in holding power - but you have to please the bureaucrats to satisfy inspections.
Re: Framing Air Nailer
NickB in Needham Mass.
>I have a PC full head framer - much less expensive than the Senco at the time, and couldn't justify anything more for the use it gets (built a playhouse, did some framing at my old house, will use it on the framing when I finish out the basement on this house). I've only had one or two jams (I've shot a couple of boxes of nails), and no problems going into LVLs with it.
Downside is it needs tools to adjust depth of drive and clear jams, but how often do you do that?
Hope this helps.
Nick
Thanks All for your Input
howard
>