Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Why you should not let things sit around

Posts

Why you should not let things sit around

#1

Why you should not let things sit around

Thomas S Stockton

>Hi all

I'm working on a pair of eliptical nightstands that have a starburst or pie veneer pattern on the top. I cut, joined and taped together the veneer while I was doing all the veneer work for the job. The pies sat sandwiched between ply for a week and a half during which time the weather changed from hot to cool and wet for 5 days. When I went to press them up this is what I found, about a 3/32" gap in the center. Bummer, I took them apart and retaped them back into half sections and redid the joint. Took about an hour. I roughly figured that the wide end expanded about 1/170" of an inch to cause the gap not a lot of movement but enough to cause problems.

Tom


img

Re: Why you should not let things sit around

#2

Re: Why you should not let things sit around

Robert W

>Thomas - I sure hope you post some pics when you get those tables finished. Looks like beautiful work.

If you don't mind, what did you cut those pieces with to get them so accurately joined together in the first place?

Thanks -

Robert

Re: Why you should not let things sit around

#3

Re: Why you should not let things sit around

Thomas S Stockton

>Robert

I use a router and a flush trim bit. The steps i use are:

Make a pattern and cut out veneers using a veneer saw.

Route one edge of veneer stack

Mark out second edge at a slightly greater angle then needed , what you want to end up with is that when half the pattern is taped up it looks like the picture only a little more sticking out at the ends.

Route the stack to this line.

Tape up veneers you can bookmatch or slip match whatever looks best. I start by taping them together in pairs then joining pairs into halfs.

This is where having a little bit greater angle comes in, I lay a jointed board across the half sections sitting on a waste piece. The board should just touch the points in the center and be even on the excess on either side. I clamp it and route it, doing one at a time.

The trick is that you don't want to route off any of the points as this looks sloppy.

I then tape the whole thing together making sure the center points line up as perfectly as possible

Tom

Re: Why you should not let things sit around

#4

Alan Young

Great for the article sections!

Alan Young

>

Re: Why you should not let things sit around

#5

Re: What Doug Stowe showed...

Glenn Madsen, SF Bay Area

>In an article in Woodwork magazine, IIRC, he used a quilter's cutting wheel to cut veneer. It stuck in my head, because there are a bunch of those in LOML's quilt room here at the house. She keeps those things sharper than any tool in my shrine. Replacement blades are available cheaply, with her 50% off coupons at the places that sell these addicts their fixes. Of course, I recognize the symptoms. ;-)

I've not used one myself yet. Partly, that's out of not doing such a project yet. And partly, it's out of respect for her tools. I don't throw rocks at the beehive, either...

Re: Why you should not let things sit around

#6

You were talking to the wrong spider.

Art Silva

>