Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

LV's Hole saw arbor . . .

Posts

LV's Hole saw arbor . . .

#1

LV's Hole saw arbor . . .

steve mackay

>Problem is I WANT the plug ! Its how I make wheels, don't ya' know. The blurb says 1/2" chuck but I figure it would probably fit in a 3/4" chuck. I'm just wondering what the travel of the "ejector action" is. The full length of the depth of my saw ? It'd still be faster than pokeing a stick through the holes in the saw to push the plug out. I also woner if I can cut a hundered plugs (wheels) and the arbor can take it. Sure would streamline the operation. I wonder . . .

Re: LV's Hole saw arbor . . .

#2

Re: LV's Hole saw arbor . . .

Kneale Brownson Dreaming of the Snow in N. MI

>Looks like it relies upon the centering drill bit to hold the material in place while the holesaw slides back off the material when the release is pushed.

Lenox makes one that has pins that push the material out.

Both are a bit pricey, but if you have to extract 100 "wheels" or more, might well be worth the cost.

Re: LV's Hole saw arbor . . .

#3

Re: LV's Hole saw arbor . . .

Bob Lemon Sacramento Ca.

>Steve,

Could you explain to me the process you are using for cutting out the wheels? Our club used to cut out thousands of them. We used a hole saw with springs in it to pop them out which wasn't very successful. We also had a lot of trouble keeping the hole saw teeth from plugging up and burning. The solution: using 2 drill presses. On the first drill press, we used a special board that would hold the wood in place so the hole saw would eject out the side. This same aboard would serve as an automatic spacer and hold the work down, so that when the saw was lifted it would not pull the wood up. The main trick is to NOT drill all the way through the board. The second drill press had a another hole saw with a smooth 1/4 guide rod (instead of a drill). The board with the partially drilled holes was inverted and task finished with the second drill. The wheels come off quite smooth with no burns and only a small ridge where top and bottom cuts come together.

Then we have another gadget for routing the edges of the wheels while keeping fingers well away from the cutter..................

I'll send you pictures if you are interested.

Bob Lemon

Re: LV's Hole saw arbor . . .

#4

Re: LV's Hole saw arbor . . .

Fred Davis

>Steve,

what size wheels are you talking?

If your not going gocart size , try Nordic Saw and Tool In Turlock , CA.. I burned up a couple of Greenlee tool steel plug cutters makeing screw plugs out of Ebony, turned them blue in a short while.

I griped about ruining 30.00 dollar plug cutters when I was ordering some saw blades from Nordic and they run up a very nice tool with carbide teeth , that I have cut thousands of plugs with over the years and it is still cutting like a new one.

Bob is in Sacramento, he should know about those guys ;-))

FredD

FredD

Re: LV's Hole saw arbor . . .

#5

Roger that . . .

steve mackay

>its not the cutting that is in question. Its the time it takes to get the "plug" out of the saw. Right now I poke it out through the holes in the side of the saw with my handy-dandy walnut pick. Boreing (pun intended) ! If LV's rig, well, "ejects" the plug from the saw it would lower my rate of frustration.