Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Completed ramp

Posts

Completed ramp

#1

JL

Completed ramp

JL

>The boards of the ramp are 4/4 southern red oak. The length of the ramp is 60" and the width is 36". I glued three boards together.

Cutting the 6 degree bevel on one end was "interesting" - I used a jig and my table saw to start each bevel and then finished up with a dozuki. After I glued up the three boards, I planed the bevel.

I used H&C "Sharkgrip" polypropylene microspheres suspended in a marine spar varnish for the top side of the ramp. Only one coat, followed by another coat of spar varnish w/o the microspheres. If you ever need to do something like this, be sure and add less than the suggested amount of "Sharkgrip" to the varnish and try a test piece. I had to dilute my initial mix a little.

The sides are 4/4 red oak and the cross-supports are 5/4 red oak. This is a "temporary" ramp and only has ~6" of rise - therefore I could get by with a 1:10 slope and no side rails.


img

Re: Completed ramp

#2

Re: Completed ramp

George@Colonel's Workshop-Havertown PA

>Good Afternoon JL,

She should be very able to negotiate that slope easily and safely. Also, its "look" is in keeping with a church interior and layout. Great job.

George

Re: Completed ramp

#3

Re: Completed ramp

John Veerkamp, Western Mo.

>Looks good JL, It should last thru many interns.

John