Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Dyeing wood with base and oxidizers

Posts

Dyeing wood with base and oxidizers

#1

Dyeing wood with base and oxidizers

Chuck Kettler Greenwood IN

>Anybody have a good resource to describe the use of sodium hydroxide and / or potassium dichromate to bring out the figure in ash or oak? Had a recipe, but lost it before trying it. Thanks.

Re: Dyeing wood with base and oxidizers

#2

Re: Dyeing wood with base and oxidizers

Bob Lemon Sacramento Ca.

>Chuck,

I use 1 (one) teaspoon lye in 16 ounces of water which gives very rapid coloring on cherry (adds 100 years in 10 seconds). Before dying, raise the grain on your wood and knock it down with a light sanding. It should be rinsed and neutralized (vinegar and water), before applying a finish. I've not tried the potassium permanganate, but the proportions are about the same. Vinegar and iron filings (clean steel wood) will give a nice blackened finish to oak and other woods high in tannins. (Allow vinegar and filings to brew for a couple of days).

WARNING: Be sure to wear protective gear!

Bob

PS: Check the archives for more information.

Re: Dyeing wood with base and oxidizers

#3

Re: Dyeing wood with base and oxidizers

Clint Searl, at the base of Haycock Mtn

>A strong solution of NaOH will do a nice etch on plain sawn mahogany. a vinegar rinse will bring back the color as well as neutralize the base.

Clint