Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

OT sorta but related to electronics etc.

Posts

OT sorta but related to electronics etc.

#1

OT sorta but related to electronics etc.

Forrest Addy

>This is OT sorta but related to electronics, PC boards and stuff that goes zap!! There's plenty here who meld electronics with woodworking machinery so I think I'm on a safe OT.

I needed a custom printed circuit board recently but what a hassle to make them. The raw board material, the artwork, the mystery of getting a good exposure, the developing and etching with nasty chemicals, and finally the drilling with dinky little drills. Expensive and a PITA but them days are gone. I discovered:

http://www.expresspcb.com/ExpressPCBHtm/Specs.htm

A printed curcuit outfit that's a one stop shop. They have a number of entry and prototype plans and they GIVE you the printed curcuit artwork for boards up to four layers.

The costs are not cheap but they are affordable for someone working on a small scale. The price beats the start up price for a few PC board by a mile. I paid $57 incl shipping for four drilled and plated boards measuring 2.5" x 3.8". I crammed four smaller boards onto the area and got 12 at about $5 ea.

Also included is circuit diagram software complete with a library of digital devices. Naturally everything is live linked. You drag the chip and the connections stretch to follow. The circuit board software is intuitive and has many features. I mastered it well enough in a few hours of fiddling to design my board and send it off via a live link to the ExpressPC. They will be shipped the next day if the design is in by deadline and you will receive them in three business days. Mine was.

No connection (no pun intended either). Just a good service I discovered and wish to share with the other wire rubbers.

There are other prototype PC board services out there but this one seemed to be almost painless.

Yes, I multiple posted this.

Re: OT sorta but related to electronics etc.

#2

Re: OT sorta but related to electronics etc.

Rod Peterson -- Ormond Beach

>Where was this 30 years ago when I was rolling my own? Tape, mylar, photo-flood, etching solution…Aaargh, that takes me back. Don't miss it a bit.

Rod

Re: OT sorta but related to electronics etc.

#3

Re: OT sorta but related to electronics etc.

John K Jordan

>Same here. If you wanted hardware for your computer in the mid '70s you either designed and built it yourself or did without. It was a good way to learn about digital logic.

The large board in the photo adapted an S100 Matrox ALT512 graphics card to my SS50 bus machine and provided some general purpose parallel control lines. The small board interfaced a joystick, before mice were available to mortals.

I used a resist pen a lot as well as those little rub-on stickers. All my boards were two layers (front and back) - more layers were not reasonably possible for the hobbyist.

JKJ


img

Re: OT sorta but related to electronics etc.

#4

Re: OT sorta but related to electronics etc.

Larry Clinton At Frankfort (Central)., Indiana

>Yeah, I once worked on a radio made in the 40's or very early 50's that was probably the for runner of printed circuit boards. It had a "stamped" copper plate attached (glued) to a phenolic board (about 1/8" - 1/4" thick as I remember). The copper must have been 30 mill or so thick - circuits were all 1/8" wide or wider and it had hand applied solder coating over all circuits. A whole lot different than the through hole/ surface mount multi-layer boards I built at my work about 50 years later. Of course back then you could replace any component on the board with a large soldering iron (or plug in new tubes).