Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Bending and moulding plexi glass

Posts

Bending and moulding plexi glass

#1

Bending and moulding plexi glass

Mark McC

>I need to make some clear sign holders for a display unit I am building for a friend. I want to use plexi glass.

Does anyone know a good/safe way to bend or mould a piece of plexi about 2"w x 6"L into basically a right angle?

Not looking for a sharp 90 degree corner on the bend, just want to roll it to +/- 90 degrees

Thanks

Mark

Re: Bending and moulding plexi glass

#2

heat

Bill Tindall, E.TN

>I don't have the details but I helped clear out a friends basement who was moving and he had all sorts of 90 bends in Plexiglas. He said he heated it and it bent readily. I forget what he said he made; I think signs of some sort.

Call the manufacturer's tech service department and they will supply all you need to know. It may even be on their web site.

Re: Bending and moulding plexi glass

#3

Re: Bending and moulding plexi glass

Eddie Pacheco: San Jose, Ca.

>Here are 2 links to videos on bending plastics. From this you can cobbles something up from available local parts. You can also clamp the piece between two 2 x 4's and use a heat gun to gun to heat the bend area and then bend the part. Too much heat and you get bubbles in the plastic.

http://www.tapplastics.com/info/video_detail.php?vid=6&format=windowsmedia&

http://www.tapplastics.com/info/video_detail.php?vid=7&format=windowsmedia&

Re: Bending and moulding plexi glass

#4

Re: Bending and moulding plexi glass

Phil Joines Krum, Tx

>This won't give you a soft line to bend, the entire piece is heated. Make sure SWMBO will be gone for a bit. Preheat the kitchen oven to 285 deg. Take the film off the piece. Put in the oven. For 1/8" thick 10-15 minutes should be enough. 14" might take 15-20 minutes. It should be very flexible when removed but it won't stay that way long. It can be reheated. If you need the finished pieces to have specific dimensions you'll need a form, there is some spring back. The shape is set as soon as it cools down.

Re: Bending and moulding plexi glass

#5

Re: Bending and moulding plexi glass

Dick Coers

>If you use polycarbonate, you can bend it in a sheet metal brake. It will bend with almost no inside radius. I didn't believe it till I tried it. Works like a charm. That's why it works as almost bullet proof. It's soft enough to absorb the bullet and not shatter.