Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Drill Doctor Question

Posts

Drill Doctor Question

#1

Drill Doctor Question

Bill Tindall, E.TN

>At the recommendation of several on this Forum I purchased the drill doctor. (How does Amazon do it so cheap!) Anyway, the Drill Doctor grind is vastly more coarse than the factory grind on my drills. That wheel must be 220 or coarser grit. It would seem that such a coarse grind will result in abbreviated edge life. Am I fretting over something I don't need to be?

Re: Drill Doctor Question

#2

Re: Drill Doctor Question

Will Abbott

>I haven't had a problem with a shorter edge life. But then again, it is so easy to sharpen a bit I never pay attention to how long it stays sharp.

Re: Drill Doctor Question

#3

Re: Drill Doctor

Mark Mandell - Gone Round In Jersey

>Haven't noticed any problem. In fact, I think the rougher edge cuts faster in wood. Since the wheel is made to be replaced for normal wear, you might check with the company to see if they have a finer grit available.

Re: Drill Doctor Question

#4

Re: Drill Doctor Question

George@Colonel's Workshop-Havertown PA

>Good Afternoon Bill,

I haven't noticed any decrease in the longevity of sharpness in bits over the few months I've had the machine.

George

Re: Drill Doctor Question

#5

Re: Drill Doctor Question

Garrett in Victoria

>Hi Bill

I believe Drill Doctor offers an even coarser grit, but not a finer one. My experience with the stock grit has been good, but I'm going to buy the coarser wheel to get very large bits ready for the stick grit.

Cheers, Garrett