Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Old Stanley level - bedding the vial

Posts

Old Stanley level - bedding the vial

#1

Old Stanley level - bedding the vial

Dan Kruitz

>I have an old wooden Stanley level (unmarked model#) that I'm trying to refurbish for my Dad. It has the glass vial I've pulled out since the old white bedding compound was no longer holding it securely. Any idea

what I should use to re-seat the vial and give me time to make sure it's level? I've removed the old flaky compound to give a good bond to the wood.

Any tips or suggestions are appreciated.

Best regards,

Dan Kruitz

Re: Old Stanley level - bedding the vial

#2

Re: Old Stanley level - bedding the vial

Tony - Memphis

>I asked the same questio over at the hand tools area. I think the reply was that they used plaster. You might post the question over there too or do a search. I have an old Stanley line level that is way off and was going to reseat the vial. Haven't gotten around to it yet. Let us know what you figure out.

Tony

Re: Old Stanley level - bedding the vial

#3

Why not Glazing compound

Dustmaker Mike

>a little Dap will do it. That is what I used years ago on mine when my then girl friend broke it. I was lucky to be working in a calibration lab with a flat granite surface the level was trued at the same time.

Re: Old Stanley level - bedding the vial

#4

Where Can I find replacement vials?

Chicago Bob

>Dan,

I have the same problem with a beautiful stanley 2' level made in cherry circa 1890. I accidentially broke the glass vial and am looking for another. Any sources or ideas???

By the way, I am sure that plaster of paris was originally used.

Regards,

Bob Haines

Re: Old Stanley level - bedding the vial

#5

Re: Why not Glazing compound

Pete in Holland, MI

>Glazing compound stays soft. Plaster, I think, is too brittle.

How bout Bondo ?

Re: Old Stanley level - bedding the vial

#6

Or epoxy?

Dan Mitchell

>

Re: Old Stanley level - bedding the vial

#7

Re: Old Stanley level - Calibration

Larry Clinton At Frankfort (Central)., Indiana

>Not too difficult, first level a surface to test it on. Take any other level, check the surface, then turn the level end for end. If the level is off, it should be off the same amount in the opposite direction after turning. Once you have established a "level" surface you can set your vial in the Stanley and "zero" it. I often check my levels this way as they can possibly go out of calibration when dropped or hit. It is kind of like checking a square by drawing a lie from a straight edge then "flipping" the square - if it is on the line in both orientations it is square.