Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

lyctid powderpost beetles

Posts

lyctid powderpost beetles

#1

lyctid powderpost beetles

JimG

>Looks like I got some. I've had a stack of hickory and mohogany down the basement for about 3 yrs now. Off the floor by 12", away from the wall by 12". Started to move it up to the garage tonight and about 1/4 the way down noticed some tiny holes and sawdust. Further investigation produced several dead and two live beetles. I am fairly sure they are lyctid - the holes are very small and the beetles look (with my glasses, that is) like the lyctid.

So, do I trash the whole pile? Do I pick thru the boards and trash any w/holes? I believe there is a couple hundred board feet of each. Do I try to get it re-dried? I really don't want to chance getting them in the house. We have a couple of rooms of wood floors.

Suggestions welcome.

Thanks,

Jim

Re: lyctid powderpost beetles

#2

Nah! The solution is labor intensive but...

Forrest Addy

>Nah! The solution is labor intensive but not expensive. Critters have to breathe and they are also sensitive to nasty vapors. Restack where you can use non-persistant bad stuff but re-stack it on a large impervious tarp. When you get the lumber stacked and stickered wrap over the material but don't seal it off. Then call the exterminator to fumigate.

I've had good luck killing off powder post beetles by wrapping my lumber stacks and slopping in some lacquer thinner. The fumes go everywhere to kill the bugs, their eggs, and larva but the poly keeps it in. I do this indoors in my racks but my shop has good exchange with outside air so any vapor leakage doesn't accumulate. If you shop is well sealed better do it in the carport. Expect to leave the material wrapped for a few weeks. More is better.

If you have powder post beetles in your lumber storage you probably have them elsewhere in your shop if not your whole house. Better consult someone.

Re: lyctid powderpost beetles

#3

Re: lyctid powderpost beetles

Scott in Eastern Iowa

>Either heat or a quick cold will likely kill them Jim.

Depending on the stack size, you might try wrapping the bunch in black visqueen and letting it warm up in the hot sun for several days or get them to a kiln with a temp of 130 for at least 24 hrs.

To be honest here, Ive done this with a small stack of red oak I bought at auction several yrs ago and am still trying to decide if it worked or not. I did it late last summer and the stack got to about 126-130 degrees in the hot July Iowa summer sun.

The cold can be done the same encasement route, but using dry ice to quick freeze them to kill. This is a new alternative method that I have not tried but it sounds promising.....

Good luck !

Re: lyctid powderpost beetles

#4

an ounce of prevention.....

Bill Tindall, E.TN

>Step 1. Carefully examine the pile to see how much damage is done. In my experience they bore a small hole into the wood and then devastate the inside.I expect the hickory is more at risk, especially the sap wood. Poke into it and see if the board is mush inside.

Step 2 If most of the lumber is ok, and I suspect the mahogany will be, you need to move quickly. The only practical approach is chemical warfare unless there is some place where you can practically heat the stack hot enough.

Step 3 You need to expose the pests to vapors that will kill them as Forest has suggested. So the approach is get the lumber on sticks, bag the pile and fumigate. Or flood the surface with a solvent that will kill them, eg lacquer solvent, dead pack the lumber and bag it. While I have not tried it, a mix of lacquer solvent and mineral spirits might be best as it will evaporate slower.

This is yet another example of why I always spray lumber to be stored with a persistent insecticide.

Re: lyctid powderpost beetles

#5

Re: lyctid powderpost beetles

JimG

>Thanks for the replies. I talked to the exterminator this morning as Forest suggested. She seems to think that it is localized to the lumber, as it is pretty well isolated from any other hardwoods (the stack being in the basement and my shop in the garage). She suggested a product to paint on that has polyethylene glycol.

What cha think? The paint approach or the lacquer thinner? Perhaps both? I gotta move it anyway. I asked her about fumigation, she said there's very few companies that do that anymore.

Thanks

jim

Re: lyctid powderpost beetles

#6

Combination

Mark Mandell - Gone Round In Jersey

>Heat and solvent.

Bag the stack in black in the sun and then soak (from one end with pump sprayer) with thinner, then seal. The heat will increase the vapor pressure of the thinner for better penetration.

Re: lyctid powderpost beetles

#7

Re: an ounce of prevention.....

Tony - Memphis

>Which insecticide do you use?

Thanks,

Tony

Re: lyctid powderpost beetles

#8

fumagate

Bill Tindall, E.TN

>You can buy fumagation "bombs" at places that sell insecticides. But better still is if you know someone with a Greenhouse. They have an "industrial strength" material that is more potent.

I have fumigated by loading my spray gun with insecticide, taping the trigger down, putting gun under the lumber tent and turning on the air as high a pressure as it goes.

Re: lyctid powderpost beetles

#9

forget the heat

Bill Tindall, E.TN

>the vapor pressure is ample at 10 below zero. You want long exposure time to diffuse solvent into the pores.