Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

OT - Cutting cast iron pipe

Posts

OT - Cutting cast iron pipe

#1

OT - Cutting cast iron pipe

Steve Silca

>I am going to tie into my home's main drain stack in the basement. Because of close quarters, I can't use a chain cutter. I have sawzall blades labeled for cast iron. Will these work OK to cut into an old, old 4" cast iron pipe?

I know that I need to brace the pipe with a riser clamp - my question just centers around cutting into the actual pipe.

Re: OT - Cutting cast iron pipe

#2

Re: OT - Cutting cast iron pipe

Kneale Brownson Dreaming of the Snow in N. MI

>I'd be concerned about the vibration fracturing the cast iron. I've cut cast iron pipe with a hack saw. Lotta work, little disturbance to the pipe assembly. Chain cutter worked best and might be worth some extra effort to make room to use one. Of course, they sometimes break the pipe too.

Re: OT - Cutting cast iron pipe

#3

Re: OT - Cutting cast iron pipe

Joseph Mulherin, Sr.

>I am suggesting that you go to a Rental shop and rent a 12" diamond bladed cutoff saw....like those that they use sometimes when cutting concrete.

Re: OT - Cutting cast iron pipe

#4

Re: OT - Cutting cast iron pipe

Joe Stallard

>I used metal cutting blades in my saws-all to make smooth cuts in 44 year old black cast iron. Just remember to wear safety glasses and go slow when you are nearing the end. It is best to support both sides of the pipe. I did this by making a temporary strap hanger. It's not as bad as some think.

Re: OT - Cutting cast iron pipe

#5

Re: OT - Cutting cast iron pipe

Justin

>I always use a 4" angle grinder with an abrasive blade. Sawzall always takes way too long, burns up blades for me. The angle grinder is nice & easy to use, & is great in close quarters.

Peace

Justin

Re: OT - Cutting cast iron pipe

#6

Re: OT - Cutting cast iron pipe

Gene Gauss

>I helped my son-in-law cut a 4" cast iron drain pipe with a sawzall about 10 years ago. We did it, but it did take a LONG time getting through it. If I had it to do over again, I'd try the angle grinder if there's enough room to get around it.

Re: OT - Cutting cast iron pipe

#7

Re: OT - Cutting cast iron pipe

Mark Mandell - Gone Round In Jersey

>Carbide "Grit-edge" blade goes through it quite well, as does a mini-grinder and a ferris metal cut-off disc.

USE A FACE SHIELD! just glasses may not be enough protection.

Re: OT - Cutting cast iron pipe

#8

Re: OT - Cutting cast iron pipe

John K Jordan

>I cut cast iron just yesterday with an abrasive cutoff wheel in a side angle grinder.

JKJ

Re: OT - Cutting cast iron pipe

#9

Re: OT - Cutting cast iron pipe - Yep

Larry Clinton At Frankfort (Central)., Indiana

>I have cut OLD cast iron pipe 6" and even 8" on occasion using a sawsall. Taint real fast and you will need a few blades to get through the pipe, (I used the Ridged blades when I was contracting) but it will make a nice clean cut if your careful. You may want to wrap a piece of masking tape or duct tape around the pipe to use as a guide to keep your cut straight as the blades do tend to wander as they dull. It isn't a pleasant task but should be no major problem.