Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

metal studs and hanging cabinets

Posts

metal studs and hanging cabinets

#1

metal studs and hanging cabinets

jeremy

>Hello,

I just moved into a condo where the studs in the wall are metal, not wood. I have a cherry cabinet that I hung on a wood studded wall by a french cleat with only two 3" wood screws. Now with metal, I don't believe it is possible even with toggle bolts but I wanted to get your(s) opinions. I would suspect I would need 100+ lbs once the cabinet is full. Any comments/suggests would be appreciated.

thanks,

jeremy

Re: metal studs and hanging cabinets

#2

Re: metal studs and hanging cabinets

Steve Jenkins, McKinney, TX.

>check out some toggles from Mc feeley. they use a 1/4-20 bolt. The toggle is held in place with a breakaway nylon thingy so you don't lose it when you take out the bolt. I used some of them to hang a HEAVY cabinet with no problems. I oriented the toggle so it was vertical in the stud and using a magnet made sure that it wasn't in the area of a sheetrock screw so it would lay flat against the inside of the stud. I'm not in the shop so I can't give you the part number or the load rating but it was several hundred pounds per in 5/8 sheetrock not in a stud. Steve

Re: metal studs and hanging cabinets

#3

Re: metal studs and hanging cabinets

George Koch

>Jeremy, You should be able to hang the cabinet using the same French cleat attached into the steel studs with self tapping sheetmetal in the same way you used the 3" wood screws previously. George