Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

Dowel Plate?

Posts

Dowel Plate?

#1

Dowel Plate?

Tony - Memphis

>Anybody made their own dowel plate? I remember an instructor once showed us that he made his own and hardened it on the grill! Anybody made their own? I might buy the Lie Nielsen and be done with it, but I thougt its somethign I won't use often,so it might be worth just making one for the size I need for this particular project.

Thanks,

Tony

Re: Dowel Plate?

#2

Re: Dowel Plate?

Garrett in Victoria

>I've made dowel plates before, and by chance, made another one just this week-end to produce a batch of 3/8" Jatoba dowels for a table.

Not rocket science. I just grab a piece of scrap steel and drill the hole size I require. In this case it was a short piece of angle iron from an old bed frame. The angle proved particularly useful in the vise.

There's no need to harden the steel unless you want to produce production quantities. Your arm will give out before the plate.

Cheers, Garrett

Re: Dowel Plate?

#3

Re: Dowel Plate?

Stephen Shepherd in the State of Deseret

>Here is a dowel plate I made from a section of wrought iron wagon tire. The big hole in the center is the bolt hole, I drilled holes for the dowels I make and another set of peened and serrated edges to put grooves into the dowels. I place it over a holdfast or bench dog hole, with a bucket underneath to catch the pegs.

I run them through the straight holes, which are also peened to turn an edge and very slightly reduce the size of the dowel pin. This cutting and compression prepares the peg or dowel for gluing.

The serrated holes are made by peening the edge then filing in notches to make the ridges for the glue to travel and provides a key for the glue to get a grip.

Stephen


img

Re: Dowel Plate?

#4

Re: Dowel Plate?

Dave Mount, NE Minnesota

>Here's the one I made. For a long time I just drilled a hole in whatever piece of steel I had laying around. Truth be told, that worked just fine. But, after seeing the LN version, I decided to make one similar to theirs. It started as 3/16" O1 which I drilled while annealed, then hardened and tempered to peacock color -- that's around 60 Rockwell if memory serves. The holes are from 1/8" to 7/16" by sixteenths. The white oak frame is rabbeted to make the surface of the plate flush and is hollow in the middle to give the pegs a place to fall.

I was going to counterbore the back side 1/64" larger about halfway through to let the pegs pass easier, but I forgot until after it was hardened and tempered, and it would probably be hard to do at that point. The surface appears black in this pic, but it's actually pretty well polished, it's just reflecting darkness from the back of the shop.

Best,

Dave


img