Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

beding drill rod

Posts

beding drill rod

#1

beding drill rod

Joe McGill

>I have some 3/8" O-1 drill rod. I want to bend it into 1/2 of a"S" shaped curve. I later intend to mount a piece of HSS on the tip as a cutter (wood turning). Therefore, I do not need to make the drill rod as hard as if it were the cutting tool, but to retore it to its origional hardness. However, I have no idea how to do any of this. Any help is ppreciated. Thanks, Joe

Re: beding drill rod

#2

Re: beding drill rod

Mark Mandell - Gone Round In Jersey

>Hi Joe,

Make my own hollowing tools from O-1 all the time.

To bend it, clamp one end in a vise and apply torch (propane, MAPP, Prestolite, oxy-acet) to the point of bend. When it gets to red, start your bend with a vice grip to hold. For a long bend, move your hot point along to allow a different bend point. When you have the shape you want, reheat the area to dull red and then let it air cool SLOWLY to prevent hardening; DO NOT QUENCH.

Tip: Since you will be fitting it with a HSS cutter, drill the end of the O-1 before you bend as it will be much more difficult to drill accurately afterwards.

mm

Re: beding drill rod

#3

Re: beding drill rod

Lee Schierer - McKean, PA

>Doesn't air cooling normalize the material making it softer than it was? I would think he would want to oil quench it to get the drill rod back to the original hardness.

Lee

Re: beding drill rod

#4

Re: Hardness

Mark Mandell - Gone Round In Jersey

>Lee,

Drill rod is supplied annealed. By normalizing it, he will prevent it from hardening. If he were to quench it (in oil for O-1) it would harden and become very brittle and easily broken; unsuitable for a tool shaft in which he will be putting a HSS cutter for a turning tool.

It would be different if he were going to harden the tip of the rod to use as the actual cutter. In that event, he should do his bending, then shape the tip for his cutter, and then reheat and harden the tip by drawing the Rc color to the tip and then quenching to hold the hardness while still keeping the toughness in the shaft.

mm