Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

MT-1 and MT-2

Posts

MT-1 and MT-2

#1

MT-1 and MT-2

Wayne Carson "TX"

>Is there a way to tell the difference between the two if they are not marked?

Re: MT-1 and MT-2

#2

Re: MT-1 and MT-2

Pete in Holland, MI

>Larger end of taper on #1 is about 7/16" dia. Not quite 3/4" on a #2.

Re: MT-1 and MT-2

#3

Re: MT-1 and MT-2

Barry Irby

>The difference is not subtle. If you have ever seen then you would know immediately which was which. No. 1 is probably smaller than your pinkie finger and No.2 is about the size of your pointer finger and No.3 is about the size of your thumb. (notice these highly accurate scientific measurements. Especially since I have never seen your hands. You are older than four aren't you?)

Re: MT-1 and MT-2

#4

Nope

Wayne Carson

>

Re: MT-1 and MT-2

#5

Re: MT-1 and MT-2 *LINK*

Bob Entwisle in NJ

>Wayne,

Here a link to MT sizes with dimensions.


http://www.woodturners.org/tech_tips/morse_taper_sizes.htm