Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Routing Plywood

Posts

Routing Plywood

#1

Routing Plywood

Gregg

>I recently routed a groove in the very end edge of 3/4" plywood. This is the back of a cabinet and I wanted to inlay the Lauan back piece flush with the side so I routed out 1/2" wide by 1/4" Deep.

I tore up the veneer face. Please someone tell me what I shoud have done (The Right Technique)

Thanks

Re: Routing Plywood

#2

Re: Routing Plywood

Chuck in ND

>How did it tear up the veneer ? I don't understand. The inside veneer ? Or outside veneer ?

Re: Routing Plywood

#3

Re: Routing Plywood

Bruce, a MN Galoot

>Just guessing, but if you were routing the plywood so that the router was balanced on the edge, what was happening was that the leading edge of the router bit was getting behind the face of the veneer and lifting it off. It's easier and better to make this rabbet cut with the router resting on the face of the plywood before you assemble the cabinet.

If this wasn't the case, then I can't answer...

bruce

Re: Routing Plywood

#4

Painters tape works great for this

Dustmaker Mike

>I use blue tape to mask the edges of ply when I route it or even cut it on a TS and have had good luck with it not chipping out.

Re: Routing Plywood

#5

Re: Painters tape works great for this

George@Colonel's Workshop-Havertown PA

>That is exactly what I do, Mike.

Gregg, don't feel like the Lone Ranger when you get raggetty edges on a plywood dado. One thing I can't do well is route plywood: it hardly ever works well for me. I have taken a sharp knife and scored the rabbet line but this takes time and works well when the score is in the precise location. MY EYES DON'T GUARANTEE THAT ANYMORE. Tape, as Mike suggests, is the best and fastest solution.

George

Re: Routing Plywood

#6

Re: Routing Plywood

Steve in Denver

>I think I would've done this with a dado blade on a TS.

Re: Routing Plywood

#7

Jesper, Denmark

Re: Routing Plywood

Jesper, Denmark

>I second the dado blade in the table saw. If onl�y a few, then the dado blade is not really necessary - a few passes with the regular blade also works.

Re: Routing Plywood

#8

Re: Routing Plywood

Barry Irby

>Me too. I would have used a TS for this.

I don't get as much mileage out of a router as I might. I wonder if a downward cutting spiral bit would have done this well. I don't own such a bit and have never tried it, but it seems it would do the job.

Re: Routing Plywood

#9

Multiple passes?

Curt Harms

>I've found when routing dados in melamine if I just cut through the melamine on the first pass then cut the dado to depth on a subsequent pass I get virtually no chipout. I suspect the same thing would help with veneer ply, very shallow first pass. Try it on a piece of scrap first, though;-)

Re: Routing Plywood

#10

Re: Multiple passes?

Bilyo

>Good point about the shallow first pass. You could also score the top veneer with a knife along the cut line before the first pass. If you are cutting perpendicular to the grain of the top veneer, this may be the best technique. If the cut is parallel to the grain, changing directions so you are making a climb cut (carefully) for the first pass may help.

Bilyo