Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

finishing breadboard ends

Posts

finishing breadboard ends

#1

finishing breadboard ends

hamish

>i'm about to finish a table 3'8" wide w/ breadboard ends and because of the seasonal movement of the wood, i'm expecting that i may even have 5/16ths of movement per side. if i'm finishing the top w/ many coats of marine spar, being that this type of finish is quite flexible, can i attach the breadboards before finishing or should they be attached after finishing. my fear is that the finish over the joint may get wrecked during movement.

Re: finishing breadboard ends

#2

Re: finishing breadboard ends

David Yoho

>Given the movement you anticipate, I'd finish them separately, which will maintain a distinguished joint line as well. No use in asking for trouble down the road!

David

Re: finishing breadboard ends

#3

Re: finishing breadboard ends

Jesse Cloud

>Good question. Been there, done that, got a nasty joint line when the wood moved (finish crackled)

You can finish them separately, or if too late for that, run a razor blade against a straight edge over the joint to ensure the break is clean and even.

Re: finishing breadboard ends

#4

JL

Re: finishing breadboard ends

JL

>I've done the razor blade scoring as Jesse suggests and it has worked fine for me - but I usually wipe on my finish as opposed to brushing it on. I also usually put a coat of wax on the outer tenons (none on the center) and tenon cheeks.

Re: finishing breadboard ends

#5

Re: finishing breadboard ends

Howard Acheson

>>> my fear is that the finish over the joint may get wrecked during movement.

It's more than a "fear", it's a certainty. Either finish them separately or score the edge as suggested.

By the way, if this is an indoor table, you would be better off using an interior varnish. Exterior varnishes contain more oil to make them flexible. Therefore, they are less protective and less water resistant. What is there about the table that leads you to believe that it needs a flexible finish?

Re: finishing breadboard ends

#6

Re: finishing breadboard ends

hamish

>i've inlaid some purpleheart, which of course turns brown/grey if it doesn't have a good uv protectant