Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Removing cosmoline..what's the best way?

Posts

Removing cosmoline..what's the best way?

#1

Alan Young

Removing cosmoline..what's the best way?

Alan Young

>I have a fairly major amount of this stuff on a recent acquisition. Any suggestions are appreciated.

Alan

Re: Removing cosmoline..what's the best way?

#2

Kerosene

Lee Schierer - McKean, PA

>Kerosene and lots of it will cut the cosmoline. Be sure to do this in a well ventilated area and to hang the rags out to air dry when you are done. You will need lots of rags. Remove the oil from the keorsene with mineral spirits.

Be sure to apply T-9 and or paste wax as soon as you remove the oil from the kerosene or your exposed cast iron will start to rust.

Lee

Re: Removing cosmoline..what's the best way?

#3

carl

Re: Removing cosmoline..what's the best way?

Carl

>I always use Brakeclean all the time works great just make sure you are outside.

Re: Removing cosmoline..what's the best way?

#4

Re: Removing cosmoline..what's the best way?

Howard Norman

>I would second the use of Kerosene to remove cosmoline.

Re: Removing cosmoline..what's the best way?

#5

WD 4-. The very best preservative remover.

Forrest Addy

>Any petroleum solvent will work to soften and remove thick waxy films of metal preservative including kerosene, mineral spirits paint remover, lighter fluid, etc. If it's soft use a plastic scraper or putty knife to remove the bulk by simply scraping. Dump the goo in an old carboard box. If the perservative is firm, spray it down with solvent and allow the preservative to soften. Then brush it with a coarse plastic brush to form a soft goo then wipe it off.

It may take serveral cleaning cycles if the preservative is resistant but perseverance will win the day and your new toy will be spandy clean.

Re: Removing cosmoline..what's the best way?

#6

sounds like a poorly disguised gloat

Robin Corell in Atascadero, CA

>

Re: Removing cosmoline..what's the best way?

#7

Jesper, Denmark

Re: Back in the good 'ol days.......

Jesper, Denmark

>In the service, the best way to remove cosmoline was a six pack to the armory sargent before he dunked your M1 Garand into the tank after inspection.

Like the saying goes." an ounce of prevention...." But that does not really address your situation.

Re: Removing cosmoline..what's the best way?

#8

Alan Young

Gloat ? Moi? Well, yup :^)

Alan Young

>Here it is. Eat your hearts out .....Hah Hah

Alan (I'll give a fuller report when it's ready)


img

Re: Removing cosmoline..what's the best way?

#9

Re: Kerosene

Howard Acheson

>The reason many will recommend kerosene as a cosmoline remover is that kerosene leaves a slight oily residue which acts as a rust preventer on those parts that many not get waxed or treated. Kerosene cuts the gunk easily and it's slow evaporation means it will stay on the surface until you wipe it off. It's also less flammable than mineral spirits, naphtha and other higher order petroleum products