Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

So what's with this trim? Or is it me?

Posts

So what's with this trim? Or is it me?

#1

Alan Young

So what's with this trim? Or is it me?

Alan Young

>I am making a "lid" for a short interior wall. The lid is some Red Oak ply over some MDF lined with a trim off the rack from the Orange Borg...


The trim profile looks more or less like this...



I fought this stuff at every corner trying to get clean 45 degree joints.

Then I held a square up to it found that the lower "flat" section seem to be set inward from the upper "flat" leaving a gap at the bottom.



So is this a bad batch of trim or is it designed for something specific like an angled crown application? Or am I just a crummy trim carpenter?

Alan

Re: So what's with this trim? Or is it me?

#2

Re: So what's with this trim? Or is it me?

fred in ct

>just a guess, but it looks warped because of the thickness and i find you really have to apply a lot of pressure when cutting to keep it flat.

Re: So what's with this trim? Or is it me?

#3

Re: So what's with this trim? Or is it me?

Dick Coers

>I would wager to say that it is chair rail and meant to be hooked over the top edge of paneling. The top section would be tight to the wall and the lower section would be sitting on 1/8" or what ever paneling thickness is these days.

Re: So what's with this trim? Or is it me?

#4

Ellis Walentine

What I'd do

Ellis Walentine

>Alan, unless you want to shim the lower section, or unless it's designed to rim over a thin piece of plywood as Dick said, all you need to do is hold both of those back faces down to your miterbox when you cut the corners. When it's nailed, the joints will be perfect (assuming the walls are square to each other, etc.).

No?

Ellis

Re: So what's with this trim? Or is it me?

#5

Alan Young

Wait till next year! er next time...

Alan Young

>Yup-That would do it Ellis. I wrote this thread-post glue-up. It was mostly out of frustration. I did get acceptable joints after some

"uh hem" .... adjustments. I didn't discover the built-in gap in the molding till it was way too late.

My parents always had a sign hanging in the house-usually next to the phone that said "Never assume Anything".

I assumed the flats were co-planer.....I was flat wrong heh hehe...

I'll post pics of the finished project....

Alan

Re: So what's with this trim? Or is it me?

#6

"trim off the rack from the Orange Borg"

Mark Goodall - ATL - tooljunkie

>You mentioned "trim off the rack from the Orange Borg" and the first thing that came to mind was "intended to irregular walls on typical house".

I've bought stuff there so bad that that it would hardly work on rounded walls.

Happy Woodworking!

Re: So what's with this trim? Or is it me?

#7

Re: "trim off the rack from the Orange Borg"

Justin Szeliga

>Whenever a client sez "I was at Home Depot (or Lowes) & saw this wonderful trim the only thing that keeps me from attacking them is the overwhelming urge to break down in tears. So much of the stuff there is SO BAD, especially the specialty stuff.

Regarding the trim from the origingal post, have you tried wetting the back w/a sponge, let it sit for a day, then see if it's flat?

Peace

JJS