Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

What Joint Type and Glue?

Posts

What Joint Type and Glue?

#1

What Joint Type and Glue?

Garrett in Victoria

>Making a simple square table base out of Jatoba to support a 40" d circular glass top. 4 legs 1 3/4" square joined by a 2x6 '+' frame mortised into the legs 6" below the top.

The question is what joint to use for the 90� crossover of the frame.

I haven't used Jatoba before, so just checking whether there's any special requirements for glue.

TIA, Garrett

Re: What Joint Type and Glue?

#2

Half lap & Titebont

Clint Searl, at the base of Haycock Mtn

>

Re: What Joint Type and Glue?

#3

Left out an important detail...

Garrett in Victoria

>The crossed boards are joined upright rather than flat, and the joint needs to be strong, because it and it alone holds the table together. I fear that a vertical half-lap won't be enough to do the job.

I'm thinking one long board with a shallow (1/8") mortise (registration only) plus 3 through dowels into 2 short boards, but is ther3 a better way?

Cheers Garrett

Re: What Joint Type and Glue?

#4

Moses Yoder

Re: half lap

Moses Yoder

>A good half lap joint is the strongest way to do this in my opinion. You need to make sure the board fits tight into the joint to prevent racking movement, or perhaps add a ring or center apron to the design. I would glue it and put a screw through the bottom apron into the top apron.

Re: What Joint Type and Glue?

#5

Half lap it shall be. Thanks to both of you.

Garrett in Victoria

>