Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Need some help adjusting a Unisaw

Posts

Need some help adjusting a Unisaw

#1

Need some help adjusting a Unisaw

Phil Joines Krum, Tx

>Been doing maintance on the TS's at work. On one on the Uni's the height adjusting rack and pinion is about ready to slip. There's less than 1/8" contact between the teeth. I can't find an adjustment to raise the pinion. As far as I can see both ends of the shaft are bushed into the castings with no adjustment. The saw it probably 15 years old. The model number is 93 G 95225 which doesn't look like a Delta number to me.

Anyone know how to adjust this thing?

I looked on the Delta/DeWalt site for the manual but if it's there I couldn't find it.

Re: Need some help adjusting a Unisaw

#2

BTW

Phil Joines Krum, Tx

>None of the tops on 4 saws are square to the blade. The miter slots are out by about 1/8". They have been using sleds to crosscut.

Re: Need some help adjusting a Unisaw

#3

JL

Re: Manuals *LINK*

JL

>Right tilt

http://www.dewaltservicenet.com/Documents/English/Instruction%20Manual/Delta/En%20422-04-651-0064.pdf


Left Tilt

Re: Need some help adjusting a Unisaw

#4

Re: Manuals

Phil Joines Krum, Tx

>I found that too. Also found some parts breakdowns on the Old Woodworking Machines site. From the looks of it there isn't a way to adjust the spacing but that doesn't make sense to me.