Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Personalized Wooden Watches, Engraved Free

Delta band saw

Posts

Delta band saw

#1

Delta band saw

Jim Hoeller

>The lower thrust bearing on a new Delta 28-276 band saw rubs against the housing and will not turn freely. How that design defect could have passed all the way into the manufacturing stage is beyond belief. Has anyone else bought this model and had the same problem?

Re: Delta band saw

#2

Re: Delta band saw

Lee Schierer - McKean, PA

>I had the same problem with mine. (It is a Chinese made saw that I purchased in Canada) When you tightened the screws properly the bearing would rub on the housing and not turn. I took mine apart, took the housing to work and clamped it up in a milling machine. I used a ball end mill and carefully milled away the aluminum until I had enough clearance for the bearing. It took less than 30 minutes to do with several trial and error assembly steps until I had enough clearance. Most any machinist with a Bridgeport could do the work for you in a jiffy.

I also added some .005" thick UHMW tape to the slide for the lower blade guide blocks to take out the free play.

Both fixes made teh saw work noticeably better.

Lee

Re: Delta band saw

#3

Here's a photo!

Lee Schierer - McKean, PA

>Here is a photo of what I did. The Dark area at the top of the photo is the milling I had to do.

Lee


img

Re: Delta band saw

#4

Re: Delta band saw

tek-Brunswick, Ohio

>I had some bad parts for my lower guide.(different Problem) Delta customer service sent me out new parts, very quickly at no cost to me. Try calling them.