Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

Help from electrically connected

Posts

Help from electrically connected

#1

Help from electrically connected

Howie in Prescott

>I have a DELTA contractors table saw (Model 34-445) with a 1-1/2hp dual capacitor motor manufactured by Marathon Motors. The saw is about 14 years old and DELTA no longer stocks parts for it. My problem is that is starts and runs with no load but labors to start and trips the overload switch when the belt is connected to the arbor even without a blade attached. My question is. Could this be caused by a bad capacitor or something more serious? I took the motor to a DELTA approved service center and they told me no one repairs small electrical motors anymore. It's cheaper to just replace them. At about $400 for a replacement I would rather buy a new saw! I hope someone can diagnose this problem. If it's just a capacitor I can replace that myself but if something more serious then that Jet Hybrid mentioned in earlier messages looks mighty tempting. I should also mention the arbor turns freely by hand so there is no binding problem there. Thanks for your help..

Re: Help from electrically connected

#2

Service centers seem to exist to tell people to

Forrest Addy

>Service centers seem to exist to tell people to buy a new one of what doesn't work anymore not keeping customer's existing equipment running. Take the motor to a motor shop. If you're good at tinkering replace the existing capacitors. 14 years is about right for a start cap. Capacitors aren't expensive and they are not difficult to replace. Your motor shop can provide them or go to Granger or some other electrical supplier.