Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Pocket Screw Question

Posts

Pocket Screw Question

#1

Pocket Screw Question

Nat Robison

>I know there are many commercially available deck fastening systems which allow you to fasten deck boards without showing the fastener.

Assuming that access isn't an issue, is there a reason not to use pocket screws (Stainless or Weather-Resistant) for deck construction?

Re: Pocket Screw Question

#2

Re: Pocket Screw Question

Lee Schierer - McKean, PA

>There are several different hidden fastening sstems available that don't require drilling of all those pocket holes that would seem to be less labor intensive. I did use some pocket holes on the steps I made for my front deck. I used stainless steel screws. The steps are two years old now with no signs of failure. However, regular pocket hole screws are not properly treated for life inside pressure treated material so thier life may be shortened due to corrosion.

lee

Re: Pocket Screw Question

#3

Re: Pocket Screw Question

ScottS

>There are a number of reasons why you probably wouldn't want to use pocket holes for building a deck. Here are a few:

1) Strength. Most of the pocket hole jigs I've seen aren't designed to work with the large screws normally used in deck building. Eb-Ty and other hidden fastener systems use small screws, but gain mechanical advantage from the "clip" or fastener used. I'd be a little worried about long-term holding power if you're planning to use a Kreg jig and the standard-sized pocket hole screws.

2) Reversibility. Remember that pocket hole screws must be used with glue to produce the strongest joint. If you glue all of your deck boards to the joists, you'll have a heck of a time replacing one should the need arise! Not that any of the hidden fastener systems are great in this regard.

3) Time. When I built my deck using Eb-Ty fasteners, I found that it was a relatively time-consuming process. Eb-Ty requires cutting one biscuit slot per joist, on both sides of every deck board. I was using Trex decking, which cuts like butter. I could literally cut the slots as fast as I could move and it still took a considerable amount of time. One nice thing about the Eb-Ty system is that it didn't require a great deal of precision. You couldn't be completely sloppy, but if there was a situation where a deck board or joist wasn't quite in the right place (due to cupping, bowing, twisting, etc) it wasn't the end of the world. Pocket screws strike me as being a bit more fussy to work with, and thus more time consuming. For a small deck, this may not be a problem. For a large deck, the time factor may be more significant.

Re: Pocket Screw Question

#4

Re: Pocket Screw Question

Pat Barber

>Kreg does offer a long screw for 2x4 construction but for a deck,

you will be there for a while drilling holes. Maybe for a small

deck or stairs but for a larger deck, the Deckmaster System is

"much" quicker, although it adds to the cost of the deck, it makes

for a "much" nicer looking deck. You have probably already researched

all the different methods.

Another "possible" solution is using aluminum angle and

drilling a bunch of holes.

This would be similar to the Deckmaster solution but much cheaper, although much slower due to all that drilling. A drill press would

be very handy for that sort of thing.

Of course, you can always just drive stainless screws and be

done with it.