Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Sorta OT: cutting palms

Posts

Sorta OT: cutting palms

#1

Sorta OT: cutting palms

John_in_Az

>Hello all - I'm posting this here because I have noticed some have worked with palm tree wood (I don't even think I would call it "wood") in turning or possibly other uses.

Here is my question. In cutting with a chain saw what kind of chain longevity is normally expected cutting palm trunks? I have tried, and find my chains dull very, very quickly. Any advice as to type of chain to use, etc. Thank, John

Re: Sorta OT: cutting palms

#2

Re: Sorta OT: cutting palms

Howard Norman

>John, I never found a chain that would last very long on a palm trunk. Of course I didn't try many but I switched to using a reciprocating saw with a 12" blade for most of my palm trimming when I lived in Phoenix.

Howard

Re: Sorta OT: cutting palms

#3

Re: Sorta OT: cutting palms

Robin Corell in Atascadero, CA

>I have not cut much palm but I do know from experiance that a round ground chain vs a square ground will hold it edge longer but a square grind will generaly cut faster.

My father cuts a lot of almond so he purchased a rapco carbide chain. A 3/8 .50 sized to fit a 20" bar cost $120 so this may not be a suitable choice for a single tree.

Also thought I would add that palm is very corosive to magnesium cased saws.

Robin

Re: Sorta OT: cutting palms

#4

Re: Sorta OT: cutting palms

John_in_Az

>Thanks for the responses. I guess I'll just have to consider a new chain to be expendable on these last two trees. Robin, thanks for the heads up about the corrosion. I just ran across another thread that mentioned the same thing. I hope a good cleaning will help prevent that. John