Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

Sharpening stakes questions?

Posts

Sharpening stakes questions?

#1

Sharpening stakes questions?

Barry Irby

>I have a chance to sell thousands of 2x2 oak stakes. Not real sure I want to do it, sounds like a lot of work. They need to be sharpened nicely. A nice symmetrical point.

Anybody got any ideas on how to do it? I have a table saw and a bandsaw, neither of which is an industrial machine.

I could rig up some sort of slide/sled to do it, but I was wondering about some sort of "pencil trimmer" gadget.

Re: Sharpening stakes questions?

#2

Re: Sharpening stakes questions?

Clint Searl, at the base of Haycock Mtn

>In one of the catalogs I have seen one of those tenon making attachments for a drill to do logs for rustic furniture. Something like that could be modified to be driven off the shaft of a 3/4hp motor. 3600 RPM would put a point on a 2x2 pretty fast. Have fun.

Clint

P.S. This is not an April Fool's joke. HaHa

Re: Sharpening stakes questions?

#3

Re: Sharpening stakes questions?

Barry Irby

>No, this is not an April Fool's Joke. I really do have a chance to sell perhaps 20,000 of these stakes. Commercial landscapers use them, apparently in huge quantities.

Re: Sharpening stakes questions?

#4

Re: Sharpening stakes questions?

Clint Searl, at the base of Haycock Mtn

>I meant my response wasn't a joke.....except maybe a little about the 3600RPM pencil sharpener.

Clint

Re: Sharpening stakes questions?

#5

Re: Sharpening stakes questions?

John Foster

>We have at the lumberyard I work at, a stake sharpener, it was under $2,000 Canadian to buy. Might be worth a look with the quantities you are talking about.

Re: Sharpening stakes questions?

#6

Here it is! *LINK*

Bill Roland (Mt Juliet,TN)

>This looks like what you need.


Sharpener

Re: Sharpening stakes questions?

#7

Re: Sharpening stakes questions?

John K Jordan

>Funny you should ask - pointing stakes is on my to-do list for tomorrow.

I've seen this same question asked on the sawmill forums. You might search there for suggestions. I think one person made a fixture for his sawmill which cut a bunch at once, but that wound not be an good option for you if you don't have a sawmill!

I always point the few I need on the radial arm saw. I made a fixture that holds the stake at an angle with the point towards the fence. Pull the saw, turn the stake 90 deg, and repeat. This would take a while with the quantities you mentioned. The biggest pain was clearing the little offcuts.

BTW, I try to make all my stakes out of black locust. It is strong and tough (almost impossible to split when pounding with a sledge hammer) and won't rot in the ground. I reuse them for years.

JKJ