Re: O.T. Spicing 18g wire together
Mark Mandell - Gone Round In Jersey
>Seems like several options.
a. Have you tried removing the special connectors so they can be reset on new cord? That would give you a home run to the wall with no splices.
b You can also consider a linesman's splice with heat shrink. Strip 1" of each wire and separate the two conductors for 2 " on both sides. Slip 2 4" pieces of heat shrink over both wires and past the splits. Put 1 2" piece of smaller heat shrink on each lead. Bring the like conductors together (ribb-to-rib, smooth-to-smooth). Twist one bare section around the other in one direction, then wrap the other around the first in the opposit direction so what you have looks like a Fisherman's knot. This splice is very strong and is used by, you guessed it, power company linesmen in the field. Slide the small heat shrink from one side over and heat, then do the same with the other. Repeat the process with the other conductor. When you've done both conductors so that they're spliced and "wrapped" with a double layer of shrunk insulation, slide the larger heat shrink over both and heat to shrink them until tight.
Takes longer to write this that it does to do the splice.
mm
[Not an electrician nor do I play one on TV]