Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Fat Edges ??

Posts

Fat Edges ??

#1

Fat Edges ??

Joe Burke

>I've been spraying some good old fashioned nitrocellulose lacquer onto some small delicate pieces, and I keep coming up with fat edges. You know, extra finish that collects around the edges adjacent to a shaped edge. Intitially on pieces aprayed vertically, but it persist even after I switched to spraying the pieces laying flat.

I've sprayed a lot of precat onto larger pieces both vertical and horizontal and any fat edge was the result of a bit too much product on a vertcal surface. In other words, a little sag. Easy to remedy, but it's proven to be stubborn with the nitro.

What am I missing??

Re: Fat Edges ??

#2

Re: Fat Edges ??

Clint Searl, at the base of Haycock Mtn

>I thin my solvent NC, acrylic, and alkyd lacquers up up to 25% and go for a wet, but not runny coat, and haven't had that problem. Don't know if the brand makes a difference, but I stick with Sherwin Williams.

Clint

Re: Fat Edges ??

#3

Re: Fat Edges ??

Sgian Dubh

>Another contributory factor that encourages the development of fat edges are sharp corners. Sharp corners make it harder for the polish to flow around smoothly. If the design allows it you could take off the arrises a bit more.

Applying a too heavy coat of course also leads to fat edges. However, if the coat is generally too heavy you'll also get curtains, runs and sags on vertical surfaces. Slainte.

Re: Fat Edges ??

#4

Sharp Corners ....

Joe Burke

>I'm inclined to see this as the most likely culprit.

I shot over 100 pieces and the only fat edges occured on the pieces that had the shaped edge. One with a typical 90 degree step just before the transition onto the flat surface. It's a small profile on a solid lumber core, veneered on both sides. I'd say I broke the arises but not much at all. The fact that I didn't see this anywhere else seems telling.

I'll have to experiment with the variables, but the bottom line is that I need for this to go away. It's a pain in my tush, but mostly, I don't like riddles I can't solve.

Re: Fat Edges ??

#5

maybe?.

tek-Brunswick, Ohio

>Many years ago I did some remodel work in a factory that made toilet partitions. When the pieces came down the spray line they had scrap pieces close to their edges but not touching them. They told me it was to even out the spray pattern. You might try that and see if it helps.