Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Safety and the table saw

Posts

Safety and the table saw

#1

Safety and the table saw

Steven R Hardy

>I have just finished returning to woodworking after an 8 year absence.Step one was to replace my old sears with a Unisaw. I considered the option of getting a new one but decided to pick up a used one and have gotten it working pretty well. I see many new guards ,holders,mitres, etc since I was last involved with woodworking. Even saw the Sawstop and read all the controversy.(I'll just say "it wont meet my needs" and leave it at that.)

Does anyone have hands off experience with a Versa Feeder...(the less than 300 dollar version)??? I am considering it for my late 70's Unisaw.

Re: Safety and the table saw

#2

Re: Safety and the table saw

Scott in Montana

>I tapped the top of my Powermatic 66 in order to bolt on the versa feeder and I like it very much. I don't use it as often as I should though. I only use it for ripping board stock and have to take it off to cut panel goods. I'm wondering if the new "super magnets" would hold it in place and therefore make it quicker to mount.

Anyhow, I installed the versa feeder to make repetitive cuts easier, but even more important was to improve the quality of my cuts... especially on cherry. No more burn marks to sand out... OK almost no more burn marks. :O)

Scott

PS If you do install a versa feeder make sure you keep the top of your saw well waxed so the stock slides easily.

Re: Safety and the table saw

#3

Re: Safety and the table saw

Jeff Scroggins

>Scott,

I would suggest that you check out the grip-tite magnetic featherboard pro system as an alternative. After using it for a few years I would not use my tablesaw without it. It is primarily a safety product, but it also has roller attachments that make it a (non-motorized) feeding system and makes it possible to dramitcally increase the quality of the cuts you make, and to make cuts that would otherwise be essentially impossible. It also makes using a tablesaw much safer and eliminates the need to ever get your fingers near the blade.

Re: Safety and the table saw

#4

Re: Safety and the table saw

Scott in Montana

>Hello Jeff,

I too use the grip tite system. My main reason for using the power feeder is for much more consistent feed speeds. The power feeder always provides much smoother, more uniform cuts, and like I said, with cherry the kerf burning is almost eliminated.

But thanks for the input, it is always welcomed.

Scott