Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

cast iron and fire

Posts

cast iron and fire

#1

cast iron and fire

DizD

>At the recycling station there was someone's shop in the metal bin - burned and blackened. There was a 4"jointer w/ stand that didn't look too bad so I got permission to pull it out. It is a Rockwell ( round nameplate with big R still intact.) All other metal ID plates missing. Guard & cutterhead bearings melted but cast iron parts look ok - the outfeed table and fence will still move.

Has anyone had any experience trying to rehab something like this? If I check tables with a straightedge and they don't appear distorted, is there anything else that would be a stopper?

Re: cast iron and fire

#2

JL

Re: cast iron and fire

JL

>My friend Mike's shop burned down about a year ago. His old Unisaw had the aluminum motor covers melted off. He has been rehabilitating it in his spare time. The cast iron is still good. The motor was pretty much toast, but the rest of it is slowly getting back into shape.

Re: cast iron and fire

#3

Re: cast iron and fire

Lee Schierer - McKean, PA

>The heat may have caused some warping of the surfaces, but it shouldn't have hurt the metal itself other than create soem hard spots depending on how it was cooled.

Lee