Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Bench Vise side vise

Posts

Bench Vise side vise

#1

Bench Vise side vise

Wayne

>I built a work bench and am having a little trouble with the side vise. When I put a piece of wood in and tighten it down the bottom tightens nicely but the top pulls away and leaves about a 1/16" gap. Without anything in the vise it closes down fine. It has a 3/4" screw with two guide rods. The jaw is 3"x8"x14" hard Maple. any ides or suggestions.

Re: Bench Vise side vise

#2

Re: Bench Vise side vise

Hank Knight

>This is a common issue with vises. Many are designed so that the jaws meet at the top first and come parallel as the vise is tightened. If your vise has wooden jaws, taper them top-to-bottom so that the top of the jaws meet first. The jaws will close on the work at the top and become parallel as you tighten.

Re: Bench Vise side vise

#3

Thanks kind of what I thought

Wayne Carson "TX"

>