general purpose blade(s) for bandsaw
Andy in Raleigh
>I finally got a "real" bandsaw, sort of. It's an old 14" ThomCo, which uses the same upper castings as Grainger/Dayton, Grizzly G1019, the oft maligned HF and numerous others, but the lower casting is slightly different and give it less under guides than most 14" saws. The good news is that Grizzly is is liquidating the riser kits for the G1019, so one is in transit and only cost me about $40 including shipping. So (stealth gloat) I will have a bandsaw with just over 10" under guides for a total outlay of under $150. I will resaw a small amount of 7" spruce and rip some 8/4 hard maple in the near future (requiring gentle curves, but mostly along the grain). I might resaw some hardwood, but I don't have any near term plans to and it would be infrequent if I do. I am keeping my little 9" with a tiny blade on it for intricate stuff. My 9" has an after market stabilizer bar (basically a steel strap) that keeps it from shimmying around so it is a decent little saw for small stuff. Anyway, because of the odd height, all my blades will be custom ordered. There is a local shop with very competitive prices, so that's no big deal except I will always incur a delay of a couple of days (if I want the best price, and I do) and can't just go grab something at the big box. Ideally, I would like to keep a blade on that meets my needs and rarely have to change it. The vast majority of cuts will be 4/4 and 8/4 hardwood. I don't think I want more than 3/8" and even that might make some cuts difficult, but I don't know if a 1/4" would put up with any resawing.
Advice is welcome (that's why I am posting :)
Thanks!
Andy



