Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

OT-Gluing tape measure to floor

Posts

OT-Gluing tape measure to floor

#1

OT-Gluing tape measure to floor

Nick in St. Louis

>Hello,

I work for a concert sound and lighting company and we are looking for a way to glue/tape down a 100' tape measure. We finally have enough room to stretch out our cables for assembly. The floor is concrete and it has some old oil left "in" it. I was thinking of using tape for wrestling mats, but my boss was thinking of using a polyurethane or some type of paintable product. It will be subjected to some light abuse from road cases rolling over it. I'd appreciate any suggestions or tips.

Thanks,

Nick

P.S. I know that the oils will pose a problem. We have run over the floor several times with a pressure washer and an automated scrubber with a degreaser.

Re: OT-Gluing tape measure to floor

#2

JL

Re: OT-Gluing tape measure to floor

JL

>I think your idea of tape is better. I would try to find a clear floor tape and tape the measure to the floor.

In my old job, we used yellow floor tape to mark the floor in the warehouse and it held up reasonably well. It took a lot of abuse (dollies, gas cylinders, pallets, etc.). You would probably have to retape it once in a while.

Re: OT-Gluing tape measure to floor

#3

1200" ? Sharpie Marker ?

Mark Goodall - ATL - tooljunkie

>100 feet is 1200 inches, right?

1200 is alot of detail... are you sure you need that much? Do you often measure lengths of cables at 92'-7"? Or do you just need markings every 10'?

We just used yellow spray paint to make a dot on the concrete and used a thick black marker to right down the measurements. I think we did 20 dots at 1 foot intervals, but perhaps you only need them every 5 feet or so.

Just a thought.

Happy Woodworking!

Re: OT-Gluing tape measure to floor

#4

Re: 1200" ? Sharpie Marker ?

ken raddon

>If you need the whole tape on the floor (good suggestion about the dots) I would use a polyurethane glue on the back of the tape. Let that dry and then put an epoxy or several coats of floor type polyurethane floor finish over it. That will hold up to tons of wear that is not a direct scraping i.e. metal table leg drug acrossed it.

Re: OT-Gluing tape measure to floor

#5

Here's one *LINK*

Lee Schierer - McKean, PA

>I did a goggle search for 100' adhesive measuring tape and found this site. They sell 100' tapes with adhesive. There are probably more out there.


100' adhesive measuring tape

Re: OT-Gluing tape measure to floor

#6

blood and bullets

John K Jordan

>Yikes, the blood splatter and bullet holes they mention might fit right in with some extreme concerts I've heard about!

BTW, the adhesive on that tape is not permanent. Sure would be cool to grind a shallow recess in the concrete and embed the tape in epoxy, flush with the surface.