Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Laminated Wood Beam

Posts

Laminated Wood Beam

#1

Laminated Wood Beam

Lar

>I aquired a a section of wooden beam from a gymnasium. It is about 14in. thick 2.5 ft wide and about 5 ft long. This beam has sat outside about 8 years but shows no sign of rot and is very sturdy. I'm not sure what it is made of but I think it's about 60 years old.

I would like to turn it into a work bench. The problem I see is that it is very weathered and i would like some idea what i should do to to make it more pleaseing to the eye. I would think it was beautiful when it was first cut. Any Ideas would be most appreciated. Just discovered this great site. I am so amazed.

Thanks Lar

Re: Laminated Wood Beam

#2

Re: Laminated Wood Beam

Bill Howatt

>Sanding is the first thing that comes to mind. A surface sander would be ideal if your beam will fit but I don't think the usual ones will take the 14 inch thickness.

Bill

Re: Laminated Wood Beam

#3

Re: Laminated Wood Beam

Scott in Montana

>Lar,

I'd start with a metal detector and a belt sander with a very aggressive belt. Pull any metal you find and then take the sander to it to see what you have. Once you determine that it's worth saving you might find a sawyer to cut it down to a usable bench top or two. Once down to rough size you have quite a few options from hand planing to renting time on a commercial wide belt sander. However, I would be concerned about the weight of the slab damaging the feed belt of the sander.

Good luck!

Scott

Re: Laminated Wood Beam

#4

Re: Laminated Wood Beam

Lar

>Thanks for the response I know there is metal running through the width about the middle. I'm going to try and sand it and see what happens. This is a very heavy beem much to heavy to move around.

I hope to try this in the next few months.

Re: Laminated Wood Beam

#5

Louie Lovas

Re: Laminated Wood Beam

Louie Lovas

>Would be interested in seeing a picture of this beam, do you have any?

Re: Laminated Wood Beam

#6

Re: Laminated Wood Beam

DizD

>Consider renting a floor sander to do the cleanup. It won't level the piece, but will get you to a point where you can decide about using it. Leveling is fairly easy with a router sled.

Re: Laminated Wood Beam

#7

Re: Laminated Wood Beam

Pete in Holland, MI

>Build a bridge crane type thing for your router and route it flat. Something like a saw horse on fixed wheels. Floor will have to be dead flat & kept clean as the horse/router is moved back & forth over the timber.

Re: Laminated Wood Beam

#8

Get hold of a floor sander

Wayne

>

Re: Laminated Wood Beam

#9

Re: Get hold of a floor sander

Lar

>Thanks for all the responses I will take a picture of the beam this weekend. I understand the idea of routng as I have built a jig for a router before. I never thought of a floor sander that sounds like a good plan.

Stand by for one very ugly but interesting peace of wood

Lar