Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

OT - NEMA 6-50P plug - Wire ga.?

Posts

OT - NEMA 6-50P plug - Wire ga.?

#1

OT - NEMA 6-50P plug - Wire ga.?

Terry Alexander

>Fellow woodworkers,

I will soon be taking possession of a Lincoln AC 225 welder. I understand that is uses a NEMA 6-50P plug.

I add a breaker in my box and run wire (a short course 0 < 20 feet) to accomodate an outlet.

I have a SquareD QO type box.

1. Do I need a 50/50 breaker or will just a 230 volt 50 amp breaker work?

2. What gauge wire should I use from the breaker to the outlet.

I am in hopes that I can use some 10 ga. 4 wire that I happen to have on hand.

As always....TIA

Terry Alexander

Re: OT - NEMA 6-50P plug - Wire ga.?

#2

Re: OT - NEMA 6-50P plug - Wire ga.?

Ray, SW Ohio

>You need to run a 6/3 cable for 50 amp. A dbl pole 50 amp braker too. My 2�.

Re: OT - NEMA 6-50P plug - Wire ga.?

#3

Ellis...(or anybody that can read this)

Terry Alexander

>When I click on my message or the "lone" response received (so far), the text appears for just a second, then disappears.

I can read messages from yesterday.

HTH in your troubleshooting.

Terry Alexander

Re: OT - NEMA 6-50P plug - Wire ga.?

#4

It should be fine now.

Ellis Walentine, Host

>

Re: OT - NEMA 6-50P plug - Wire ga.?

#5

Re: It should be fine now....Not yet

Terry Alexander

>I can see/read the text in "Weekend accomplishments". Any messages above that does not show the text.

Sorry for the bad news.

Re: OT - NEMA 6-50P plug - Wire ga.?

#6

Re: Perhaps save a step

Al Stokka - Cambridge, Iowa

>Terry,

It might help Ellis if you tell him what browser you use as well as which operating system. Versions, too.

Al

Re: OT - NEMA 6-50P plug - Wire ga.?

#7

Re: OT - NEMA 6-50P plug - Wire ga.?

ScottS

>I am not an electrician, but I am a hobbyist welder. My MIG and TIG welders both have NEMA 6-50P plugs, though they only drawn 30A max. I connect them to my NEMA 10-30R 220V dryer outlet with an 8-gauge 3-wire extension cord. Unfortunately, my electrical box is full so I can't add a dedicated circuit for the welders without a new box and a service upgrade. Participants in the welding forums I frequented seemed split on whether to use 8-gauge or 10-gauge wire. Price difference wasn't huge, and the cable runs are longer than I'd like, so I went with the larger size.