Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Sand Paper for Performax?????

Posts

Sand Paper for Performax?????

#1

Sand Paper for Performax?????

Barry Irby

>I have some sandpaper strips that might work for my Performax, but they are too short and too wide.

Has anyone tried changing the angle of the wrap so that you could use shorter but wider strips? How did you work it out?

Re: Sand Paper for Performax?????

#2

Re: Sand Paper for Performax?????

DizD

>I did it by trial and error. I took a roll of freezer paper and cut the roll with a table saw (or band saw?), to an estimated width,

say 4", unrolled a strip and then cut angle on one end (you may have to adjust this) and wrapped it on the drum. At takeup end you have to estimate the angle & length and trim to fit. I wound up taking 1/4" increments off the width until I got the match to the sanding belt length I had. From the paper pattern, make a templete, lay it on back of belt & slice it off.