Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

David Marks - Dangerous cut?

Posts

David Marks - Dangerous cut?

#1

David Marks - Dangerous cut?

Terry Alexander

>I watch David Marks a lot and I have an observation.

I have seen him (many times) make a crosscut on a long board and the end of the board is pressed against his TS fence. Example: He might have a board 3-' long and just need a small cut off the end. He will place the board in his crosscut sled and the end of the board rides against his TS fence. Seems to me this would be ripe for a "bind" and associated kickback?

All comments are welcome.

Terry Alexander

Re: David Marks - Dangerous cut?

#2

A.J. Hamler

Re: David Marks - Dangerous cut?

A.J. Hamler

>Generally, I'd tend to agree, but if he's using a sled and the workpiece is securely against the sled fence, it should be fine.

Still, being the table-saw paranoid that I am, I'd probably use a stand-off block on the fence to set up the cut, which would clear the block as I pushed the sled past the block.

But again, with a sled I don't think it's all that dangerous, especially for someone who's been doing it as long as he has.

A.J.

Re: David Marks - Dangerous cut?

#3

You gotta emember . . .

steve mackay

>that Dude's TS sled is a MONSTER ! He could probably throw a log on it and slide it right through. Probably has.

Re: David Marks - Dangerous cut?

#4

Re: David Marks - Dangerous cut?

Bill Howatt

>If the fence is perfectly aligned at 90 degrees to the sled along its length then it isn't a problem since it can't bind. However, I bet most setups aren't that good and I don't think it is good practice anyway.

I don't agree with one of the replys that mentioned about how long he has been doing it. How many posts have we seen about serious accidents that have happened to people who have been using woodworking equipment without incident for many years and then, one day, ....

Bill

Re: David Marks - Dangerous cut?

#5

Re: David Marks - Dangerous cut?

Tony - Memphis

>Yeah, just recently, Ellis had a friend that had an incident. Experience does not outweigh safety. I've enjoyed reading David Marc's articles in Popular Woodworking recently as a refresher and to make safety a current thought, not something I USED to think about.

Let's be careful out there!

Tony