Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Removing a drill chuck

Posts

Removing a drill chuck

#1

Removing a drill chuck

Doug Ridley

>My buddy asked me to change the worn out chuck on an old B&D 3/8 inch drill and for the life of me I can't figure out how to get the old chuck off. To complicate matters further there is a bit in it and I can't even get that out. Any suggestions?

Doug

Re: Removing a drill chuck

#2

Re: Removing a drill chuck

Keith Newton------WebKitFormBoundaryZPoA43GU3Ns+ew

>You will have to get the bit out first. Use something like a screwdriver blade to tap against the chuck teeth while someone else is turning the key to give it an extra breaking power. You may want to try some liquid wrench if it is rusty.

There is usually a screw in the bottom when the jaws are all of the way open. The threads are normally left hand.

Re: Removing a drill chuck

#3

Right on and

Lee Schierer - McKean, PA

>The threads holding on tehe chuck can be really tight. The hard part is holding the drill motor still while breaking the chuck free.

Lee

Re: Removing a drill chuck

#4

Re: Right on and

Scott Blundell

>I had a chuck that had "sticky" spots and was rusted and generally worn out. I opend it up and took out the screw in the bottom, but then could not get the chuck off. I finally gave up and put the screw back in. Oddly, the check has worked perfectly for thepast 2 years, must have really scared it.

Re: Removing a drill chuck

#5

Re: Removing a drill chuck

rarebear

>Two pair or channel locks or vise grips to get the bit out first..

You have a phillps LH screw at bottom of bit hole and a LH thread on chuck.. Clamp chuck on out side and use drill motor to spin off chuch LH (reverse)

Re: Removing a drill chuck

#6

Now the easy part.

Neal in San Jose

>Once you have removed the screw down inside the chuck, put the short arm of a large allen wrench in the chuck, tighten it down, and smack the long arm of the allen wrench with a piece of pipe or something else heavy so that it goes the same direction that it would normally turn when going forward. Inertia will keep the drill motor from turning, and the chuck should spin right off.

Re: Removing a drill chuck

#7

Re: Removing a drill chuck

Doug Ridley

>Well I got the bit out and the screw is already gone. Now, how in the world can I hold the motor still and break the threads loose on the chuck? Any ideas? I can hold the motor still wuth a screwdriver stuck in the vanes but I'm afraid to try very hard to turn the chuck off for fear I'll break the vanes. There has to be a better way. Help!!

Re: Removing a drill chuck

#8

Re: Removing a drill chuck

Doug Ridley

>Got it!! Thanks, guys. Your tips did the trick.

Doug

Re: Removing a drill chuck

#9

Re: Removing a drill chuck

Doug Ridley

>Now, one more question. Where can I find a screw to go down in the center to keep the chuck on when in reverse? Is it a special screw or can I just get one anywhere as long as it fits?

Re: Removing a drill chuck

#10

Re: Removing a drill chuck

John Veerkamp

>If it fits you must acquit. Oh that was another matter. Doug, if the threads work just be sure to get one that is not too long. Allen head(button head cap screws) work great in this application.

John

Re: Removing a drill chuck

#11

Re: Removing a drill chuck

Doug Ridley

>Thanks John. That will wind this up. Thanks to all for the tips.