Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Resawing Outta Wack

Posts

Resawing Outta Wack

#1

Resawing Outta Wack

Howard

>I have the Delta 14" bandsaw. Tires were not coplanar so I put 2 washers behind top tire and now they are. Installed new tension spring. Only not yet tried is a new blade(just ordered one). Any other ideas why I would still be getting drift when resawing???

Thanks, I'm out of ideas. I don't think the tires are warped, though I have not checked.

Re: Resawing Outta Wack

#2

Re: Resawing Outta Wack

Grant in Iowa

>Howard,

When you get your new blade, I suggest you perform the following test:

-take a board at least 12" long and with one straight edge and draw a line parallel to and about an inch from that edge

-Set up your saw, and without using the fence begin cutting along the line by freehand cutting. Follow the line until you find the equilibrium point and can cut along the line with no side to side corrective movements and then STOP cutting where you are, hold the board at that angle and shut off the saw.

-Set up you saw fence parallel to this line, and you should be able to use the fence (with that blade and that saw alignment) to cut parallel to the fence.

-If you find that you can't reach an equilibrium point and are constantly correcting left to right in order to foillow a line, then your blade is dull or perhaps inappropriate for the material being cut.

Hope that helps,

Grant in Iowa

Re: Resawing Outta Wack

#3

I should add:

Grant in Iowa

>If you perform my test outlined above and find that your angle of cut is waaay off from square, then you can back off your guides and adjust tracking on the saw to bring it closer to square. If the infeed end of your test board is to the right, then adjust tracking to bring the blade forward on the wheels. If the infeed end of your test board is to the left of the blade, then you should adjust tracking to move the blade toward the rear of the wheels. It is possible to get the tracking set such that you have no blade lead with a given specific blade.

Regards,

Grant in Iowa

Re: Resawing Outta Wack

#4

Re: I should add:

Paul Waddle

>I'm no expert,but besure the wheels are coplanar when you have TENSION on them. A slight angle is necesssary for tracking,but its hardly noticeable. I won't tell you to do this,but my saw runs better if the bottom guide is a little wider than the .003 cleareance recommended. Also.besure your table is SQUARE.Then adjust blade to it. That turned out to be my biggest problem,the table would rock slightly,this put everthing in a bind. After you once achieve good results,its sorta self teaching. I was surprised when the riser was installed, it didn't make it harder to resaw. pw

Re: Resawing Outta Wack

#5

Thanks-Hopefully New Blade Does it

Howard

>

Re: Resawing Outta Wack

#6

blsde width

Bill Tindall, E.TN

>My drift problems got solved when I went from a 1/4 to a 1/2 " blade.