Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

I need help finding a hinge,

Posts

I need help finding a hinge,

#1

I need help finding a hinge,

Keith Newton

>Like James Krenov would use. It needs to be a brass pivot hinge. The part which mounts on the top and bottom edge of the door is about 1/8" thick, L shape, 3/8" x 3" on the long arm.

The cabinet part is about 3/8" x 1.5" long. I have used these a lot through the years, but have loaned my catalogs out, or left them with customers to choose pulls, and didn't get them back. I have wasted more than an hour looking online, but I need a part #

If someone has a catalog, and could look under pivot hinge, or knife hinge will get you on the page. Thanks

Re: I need help finding a hinge,

#2

Re: I need help finding a hinge, *LINK*

Stephen Shepherd in the State of Deseret

>Lee Valley sells them. I repaired an old wardrobe and the pivot hinges were made from the ramrod guide from a muzzleloading rifle.

Stephen


Pivot/Knife Hinge

Re: I need help finding a hinge,

#3

That is not it. I need L

Keith Newton

>The door part needs to be L shaped because it is inset.

I can find them where both parts are L shaped, but I don't want to have to mortise the carcass part because the cabinet is already made, and I can't get a router into the corner.

Thanks for trying. The one that I want would be on the same page as this, but I can't find it without a part #.

Re: I need help finding a hinge,

#4

Re: That is not it. I need L *LINK*

Stephen Shepherd in the State of Deseret

>How about this one.

Stephen


L-hinge

Re: I need help finding a hinge,

#5

Try looking for clock case hardware

Rod Peterson -- Ormond Beach

>I've used those for the door in the hood of a tall case clock (grandfather/grandmother). KlocKit has them. I'm sure there must be other places, too.

Rod

Re: I need help finding a hinge,

#6

Re: I need help finding a hinge, *LINK*

Ed Mulligan, Cape Cod

>Keith

There are six possibilities at page 2 of the link. Ed

http://www.whitechapel-ltd.com/Merchant2/merchant.mvc?Screen=CTGY&Store_Code=wc&Category_Code=sphng&Offset=


Whitechapel

Re: I need help finding a hinge,

#7

Thanks, Order placed

Keith Newton

>Not what I wanted to find, but close enough. I can make the base part easier than continuing the hunt.

Dang those things are expensive for such a simple hinge. If I needed more than just two pair, I think I would jig up and make my own.

Re: I need help finding a hinge,

#8

Re: Thanks, Order placed

Mac

>Whitechapel gives a substantial discount to businesses(business card?)

Re: I need help finding a hinge,

#9

Re: I need help finding a hinge,

Sonny Asburry

>I read that you had already ordered the hinge, but for future use, here is a source that might be of use.

It is located here in Martinsville, Va.

I have no affiliation, nor have I dealt with them.

I hope this helps.

coolknobandpulls.com

Sonny