Re: Refinishing hardwood floor Q's
dtenney
>I've done quite a few floors. Bot new installs and refinishes.
If the floor is in bad shape, you will have to use a drum sander...No way around it.
Here's a pretty good article on this:
http://www.hammerzone.com/archives/flooring/hardwood/sanding/drum.htm
If the floor is in decent shape and just needs the finish knocked off, you can use a random orbital saner. This type of unit has 4 6" pads on the bottom of the machine. When I use this I only use two grits...The roughest (usually 24) and 80 grit to finish. I use this on new floor installs also.
When you finish the floor, put down a coat of shellac based sanding sealer. This will make the job go a lot faster. After the shellac dries, put down your first coat of poly. After that dries, sand the whole floor with 80 grit in a pad sander. Then whip the floor down with warm water and towel off. You can now apply the final coat of poly.
I've used different brands of polyurethane, and haven't noticed any difference between them. I mainly use Parks now because it is the cheapest and looks\works the same as the more expensive brands. You can buy it at HD.
Hope that helps.
dave