>There was a posting some time ago about how to get rid of worms in our lumber, something about "cooking" it in the stove and/or treating it with some insecticide. My "search" did not reveal the original posting. I was milling some walnut from my wood shed and found worms in the sapwood and, powder on the floor. I cut as much of the sap wood off as I could but, don't want to take chances with the final project.
>I have never had any problems with any type of bugs getting in the heart wood in walnut. I have had such good luck in this regard that when I get wood that has bugs rather than stack it with something less valuable I will stack it with the walnut because I know the bugs won't bother the walnut. both termites and powderpost beatles will stay out of the heart wood.
If the wood is freshly cut and still green you can treat it with borate if you are woried about it. to be effective the wood has to be wet.
>Some years ago I was standing in my shop next to a supply of walnut turning squares on a shelf (about ear level) when I heard a faint "scritch, scritch" sound. I actually watched a powderpost beetle break through and exit the end of a piece of walnut! That has to be some kind of rare event.
These were pieces a friend gave me that had been stored outside for years under a tarp. Cutting into a few, I found many beetle tracks. Perhaps the storage location had been too damp.
Amazingly, I also witnessed the other end of the process. A few years later my chainsaw and I were processing a maple log into big turning blocks outdoors (near a wooded area). I noticed an invasion of small black flying insects, evidently attracted by the scent of the freshly cut maple. These little guys began landing on the blocks and chewing into the end grain!
Note that there is more than one type of PPB and they have different tastes.
>So, I have powderpost beatles in walnut hardwood that I would like to be able to use in furniture. How do I get rid of them? I read about cooking the pieces in the oven. At what temp for how long?
"Heat (over 130 F for 24 hours or more is required) is very effective in killing the eggs and the insects. After the insects lay their eggs, it may be up to two years before they hatch, so be careful about an inspection that shows no further damage--there can be more in a while." Gene Wengert, Wood Web forum technical advisor