Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Find a woodworking club near you

Raised panel door

Posts

Raised panel door

#1

Raised panel door

GarryF

>I made my first raised panel door today using freud 3 piece router bits. When I dry fit them , even though the rails & styles fit tight in measuring corner to corner for squareness ...I'm off 1/16th. I have checked all measurements & all seem to be correct. Even without the panel inserted they are off. Any ideas as to what can cause this? and how to correct?

Re: Raised panel door

#2

Re: Raised panel door

Ed Mulligan, Cape Cod

>I think being a sixteenth off on your first try is a good outcome.

Put the dry assembly on a true surface like a tablesaw top and try to narrow down the problem. Is the door a parallelogram? Is one stile tapered? Are the components flat and square?

I'd look especially at your milling technique and the squareness of your jig for tenoning the rails.

If you checked for square with the door in clamps, it is easy to throw the assembly out of square if your clamps are placed wrong or you have unequal pressure on them.

To correct, assemble, plane a 32nd off the high corners, and move on.

Ed

Re: Raised panel door

#3

Re: Raised panel door

Frank Bergmaier

>Hi, we are probably using the same Freud set family. Measure the tongue for the stile/rail set. I found it off by 1/32" from what they specify in the manual. Times two you end up with 1/16". Change the constant in Freud's formula to what the real value is and you should come in dead-on as I did. For my initial try, as suggested, I just trimmed back 1/32" on each stile.

Hope this helps,

Frank

Re: Raised panel door

#4

Re: Raised panel door

GarryF

>Frank & Ed..thanks for the response.....I decided to see if the rails were square...guess what they were not...all my careful jig layout somhow they were not cut square...so I squared them up...fit like a charm & Square!...Frank you were right about the bits being off. thanks for your fast response.