Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Jointer Problem Revisited

Posts

Jointer Problem Revisited

#1

Jointer Problem Revisited

Tomm

>Thank you for all who wrote about seeing light and not seeing light before gluing boards together. Someone asked if the jointer was properly tuned. I have never been able to tune the jointer and always thought the fence was warped. I bought two expensive straight edges and used the longest one and found out the table was off .002 in the middle of both beds. That should not be enough to cause gaps in the boards. After three years of messing with everything that should make the jointer work properly and lots of calls to the tech line for help, I finally discovered that the beds do not line up side to side. They are off .018 in the six inch span. I think it is time for a new jointer.

Re: Jointer Problem Revisited

#2

Re: Jointer Problem Revisited

Roger Lance in GR, Michigan

>or adjust/shim the tables.

Re: Jointer Problem Revisited

#3

Ellis Walentine

Don't junk it yet

Ellis Walentine

>Get yourself some brass shim stock and shim whichever side is low. I don't know how you adjust your knives, but if you use a jig that references the height off the surface of the cutterhead, then you will have to align both tables to the surface of the cutterhead as well, to ensure that the knives and tables are coplanar. If you adjust your knives manually by using a straightedge on the outfeed table, then it isn't critical whether the tables are coplanar to the cutterhead; you only need to shim them level with each other. Since the elevation of the ways is 45�, the correct shim thickness for an .018" difference would be .018" � 1.414 = .0127".

To shim a wedge-bed jointer table, loosen the gibs until you can lift the low side of the table enough to put a strip of shim stock in the gap. If the beds are coplanar over their length, you don't want to change that, so use shims that are the full length of the way you are shimming.

Ellis Walentine, Host

Ellis Walentine, Host

Re: Jointer Problem Revisited

#4

Re: Jointer Problem Revisited

Dan Mitchell

>Since I'm in the market for a jointer I have to ask, what is the make & model of yours?

Thanks

Dan